Wireless

Hello,I use a cisco 4404 & ACS 4.1I've no L2 security. I use an external Web auth page.My question is the following:How to verify the SSId that the user use to login WITHOUT L2 security (802.1X)?I've set the allow AAA overide for each SSID.I've tried...

Hello All,I have some Cisco 1130 Ag WiFi AP and on these devices multiple SSIDs. I would like to monitor the number of connected users to the SSIDs, (I need statistics per SSIDs). I try to find the required SNMP MIB, but withoun any success till now....

Does anyone have any suggestions on how to get more granular reporting? Specifically we have separate controllers for our sites and need the number of clients that connect each week. The on demand reporting does provide peak usage report over a 7 day...

HiI am running PEAP-MSCHAPv2 , all Clients are Windows Xp SP2 on an AD domain and all clients have wireless configuration assigned via Group Policy. All machines except for 10 machines running the PI21AG PCI WLAN adaptors are able to authenticate usi...

I was playing around with the config of a Cisco 1030 from my WLC, and set the mode to "bridge". And hit the Save button. Now the 1030 endlessly reboots itself, and the WLC no longer sees it. Is there a way to reset to factory defaults without the WLC...

I have just installed a Linksys WRV54G VPN router and I am trying to set it up securely. At this point when I access it, the Windos message is that it is an unsecured wireless network. I was hoping to have a use be required to supply a user name and ...

we configured a 1242 AP with a static IP that's on the same subnet as the rest of our network. we were able to finish configuring the AP-SSID, etc via web-ing into the AP when it was plugged into a network switch. We then powered it off and took it t...

Has anyone configured a 11xx series AP with 3 SSID? and more importantly can I have 1 SSID WEP and the others WPA? I have a client that wants to use VoIP phones that only support WEP, but I would like the guest and LAN SSID VLAN to use WPA...Any comm...

Dear All,I wanted to ask whether AIRANT-24120 or other high gain bridge antennas can be used to provide Access point capabilities with 1300 series AP.My scenario is that, that i wanted to give roaming services to my WIFI clients in approx 15km range....

Hi, Im looking for possibility to configure Cisco Access Points for PPPoE and VPDN anybody knows pls reply to [email protected]. tks

Hello Everyone, I am using two 1310 bridges in a root / non-root setup. The switches on both sides of the wireless bridge were setup to trunk native vlan 253. Each wireless bridge also had vlan 253 setup as a Radio and Ethernet Interface. In this con...

How many clients can each access point support. I cannot find any documentation. Thanks for your help.

Hi,I posted a question a week or so ago about setting up an 877W with wireless and VPN back to headend site. The requirement is for the remote site (5 + users) to VPN to main site but have wireless locally with authentication via PEAP into headend si...

Hi thereWe have a wlc 4400 and i have pulled the log for the error codes/events off it.I need to decode these messages now to understand what I am seeing.Where can I do that ?Is there a decoder/debugger for these messages ?for example..Fri Feb 9 03:4...