Wireless

I got the following hardware:1x Cisco Systems AIR-CT5508-12-K96x Cisco Systems AIR-AP1142N-E-K9 I have to set up a guest WLAN network that has no access to the local network (192.168.0.0/24), only to the internet.Currently I am using the management V...

Hi We have two WLCs 5520 and 9800.We are facing continuous ping drops and low bandwidth issue when we connect AP 3802I-E-K9 with 9800. These 3800 series APs are working fine with WLC 5200 We raised a ticket with cisco support and upon their recommend...

Hi, We have recently noticed that the WLC device certificate has expired on our 5508 platform, and believe this is now preventing APs from joining the Controller. The 8.3.135.0 code includes the ability to configure "config ap cert-expiry-ignore mic ...

Hi all, I have air-ap2802i-b-k9 which I need to setup and I am totally new to cisco products.From guides I understood that I need WLC, but I dont have any.I read that I can use Mobility Express, but as I understand I need to have K9C model in order t...

Hi to all, I use C3702e (autonomous mode) and C1852e (Mobility Express) device to have Wifi are in my house.I notice that C1852e use Mobility Express, it seems that all setup can be done through webinterface.But for security reason, i don't want to a...

Hi all,This happend yesterday to one of our office access points (AIR-LAP1131AG-E-K9). The circle was flashing with all kinds of colors, I took it down to our servicedesk and plugged in the console cable and it was saying the following: %CAPWAP-3-ERR...

Hello, I'm using WLC 2504 with one access point and and spectrum cable modem.  The AP and WLC are connected to a switch, the switch is connected to the spectrum cable which is used for DHCP. The AP is getting an IP but not joining the WLC.  I'm only ...

I have AIR-CAP1532E-E-K9 which fails to broadcast signal or transmit network after joining the WLC ever since i changed from 8 port to 24 port switch, please anyone with possible help or assistance?Instead of the stable green its going amber, red and...

I want to configure 9800-l WLC with local webauth for guest users create on wlc to provice inernet access. Its a new GUI of WLC and coudn't unterstand how to configure local webauth  for guest SSID users.. Webpage is not redurecting and open for user...

Greetings, Would you able to advise how to make sure that clients who support 5G Wireless can connect to 5G when the 9120 AP is deployed ?. Right now the clients who join the wireless network connect using 2.4G even though they support 5G. Regards,Ed...

Please help to clarify difference between "SmartNet for AP adder license for Controller" vs "SmartNet for AP".

Hi   WLC 5520  and ISE i got a question, in case of central authentication 802.1x with ISE, and the WLC is failed is there a method to configure the flexconnect AP to continue to authenticate new users that would  access the network using the Radius ...