In our office Going to Purchase C9800-L-F-K9 Controller. and C9105AXI-E Access Point. But We are already using AIR-AP1832I-D-K9 Access Point here. Will C9800-L-F-K9 Controller support AIR-AP1832I-D-K9 Access point?. Please Clarify my doubt.. I really...
Forum Posts
Hi ! I'm having an issue with the C9800 interfaces (on the Bengaluru 17.5.1 version) on an hyper-v setup. My virtual machine can only have one giga interface on the hyper-v vswitch (untagged).Is there any way to configure the giga1 interface so the A...
Hi to all, I have AP 1850 with Mobility express. There is 3 SSID's on that AP, one of them is for guest network. Everything works fine except one issue, I can access ME controller from guest network. I cannot access any other device in other vlans, e...
We have got the WLC9800 controller and the cisco 9115ax-e AP. Im having issues connecting the AP to the controller. I have manually configured static controller address on the AP but it doesnt seem to connect. It sends out the discovery packet but do...
Planning to implement a wireless network having 1572 series access point, which will be having both omni and directional antenna. In a single AP, shall we connect 1 x air-ant2513p4m-n=(directional antenna) & 2 x AIR-ANT2568VG-N=(omni antenna) to serv...
Hi, Thanks in advance, Can I connect Cisco AIR Ap 1832I access point with Cisco Ap 1852i controller.
Resolved! [CG418-E] IOS XE Software upgrade
Hello,I'm testing the Cellular Gateway CG418-E. When I try to upgrade that CG418-E with IOS XE Software release Amsterdam-17.3.4a (downloaded on https://www.cisco.com/c/en/us/support/routers/catalyst-cellular-gateways/series.html#~tab-downloads, Prod...
Does anyone have an .ant file for the Cisco AIR-ANT2568VG-N antenna?It is for an RF Planning tool.
I have a 618,000 sqft warehouse I need to upgrade wireless to. I'm limited with deploying 9120axi for this one. The survey shows moderate coverage for a -10dB barcode offset with 24 Motorola APs, which are currently at maximum transmit power. APs are...
Hello world! What's nowadays the common way to connect a remote building (access switch) via wireless to the (wired) network? In the past often standalone APs configured as Workgroup Bridge (WGB) were used. What's the recommendation today? I don't wa...
Hello,Due to the AP shortage we are making do with Ubiquiti AP's.We'll have Meraki firewalls and switching. Any potential issues with this set up in terms of setting up RADIUS authentication?
This might be in the wrong location. I am replacing a failed Hard Drive on a Prime Infrastructure Appliance (Gen 2). Is there a set of instructions on how to proceed with this replacement?
I'm working with a school district where primarily Apple devices are used. As a result of using iPads and MacBooks at school, staff and students tend to have iPhones as their personal devices.There is no BYOD network for students, they are allowed to...
Resolved! WLC 5520 Call Home issue
Hello, We have recently upgraded our WLC 5520 from 8.2.170.0 to 8.5.171.0.Since we have this message on the smart license status : It seems it's working, we are correctly registered and Authorized, however we can see "Last Communication Attempt : Fai...
hi,i got a problem is there any way to configure ( air-ap1832i-i-k9 ) without a console or controller
