Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Hello I have access point installed a solar panel and is next to the GSM cellular network antenna Telecom SO i have two problem !! 1) i want to know if solar panel and GSM cellular network antenna are two reasons for low throughput !!! ?? pr...
Resolved! Cisco 2802 and Spectrum expert (ME mode)
Hello!Is there ability to connect Cisco 2802 Access point running mobility express software to connect to Spectrum Analizer? What I find in internet is only way to connect lightweight AP to spectrum analyzer.
Hi all,Recently encountered a problem, the AP will suddenly be collectively disconnected, and the controller cannot be managed by logging in to the web. At the beginning, it took about 1 hour to complete the ap registration. Now the registration is c...
Good day all, i am looking at more information on how the tls verification will be done when a client connects to the specific ssid. and how is the certificate status performed, does the wireless controller check it directly with the server having c...
Hi everyone,Recently encountered a problem, the AP will suddenly be collectively disconnected, and the controller cannot be managed by logging in to the web. At the beginning, it took about 1 hour to complete the ap registration. Now the registration...
This question is much more a Microsoft/Windows question than a Meraki question, but I expect some of you guys have experience with NPS and may be able to help.I have RADIUS working for AD authentication using what will be my "fallback" policy in the ...
Resolved! Migration from Aruba to Cisco
Hi Experts, I am migrating the Aruba WLC's to Cisco 3504 in an office.The users connect to XYZ SSID, once i migrate the controller and AP's to Cisco and the Cisco AP's broadcast the same SSID will the user PC automatically connect or they have to con...
I have a query regarding the OUI update in WLC. In HA deployment, do we need to reboot only primary WLC or both the active and standby after the OUI update ?
Good Evening All, I am having a weird issue and maybe I am mistaken, but I am pretty sure we can run wpa2/psk plus mac filtering. I have an SSID that is configured with wpa2/psk. I want to enable mac filtering, so when I do and apply the config, the ...
Hi,I just upgraded firmware of WLC to 17.3.20200621 but after the upgrade, whenever i login to controller it shows password policy message.I tried configuring password policy by going to Configuration -> AAA -> AAA Advanced -> Password policymade one...
Hello, I recently purchased three Aironet 1815i Access Points. I was able to get them configured out of the box and it appeared everything was up and running. I am using version 8-5-161-0 and using Mobility Express. I was adding additional Cisco SG35...
Did the latency graph and QoS view disappear from Wireless Health in the portal? I saw it on Monday (7/27/2020) but it is gone today. No firmware on MR was performed during this time.
I use tp-link RE200. It works fine with MR33.But then I keep receiving alerts of the rogue DHCP server at the address of the RE200.Any suggestions to set the RE200 DHCP valid or avoid the alert?Thanks.
Resolved! Is Wireless packets encrypted?
simple question.. is traffic encrypted over the Control and Data channels? If it isn't how can I set it up?
