Hello, I have a problem integrating 2 x ASR9000 with 2 x 7600The topology is Just simpleA9k--------A9K | |7600------7600ASR 9000 is running MST , while 7600 is running PVST all attached using a Single Tengig Interface.The problem I have ...
Hi all,I am in the middle of NAT configuration testing for new ASR9010 implementation. Customer need NAT feature and ordered ISM for the CGN. Need your help to check our configuration and the testing environtment, because we found this configuration ...
Hello,we are trying to configure NAT64 on ISM. We are running 4.3.0 on ASR9k and allpackages are installed.Problem is that the config guide is "incomplete" and the NAT64 config is not wellexplained. I will paste the config and show command output.. R...
HelloI'm the network engineer in service provider with 50000 subscribers.We plan to change connection technology from pppoe to ipoe.So we decided to buy ASR routers. But we still can't choose between ASR1k and ASR9k.Our needs: 50000 concurrent ipoe c...
HiMy understanding is that is that there is no MAC address learning on an xconnect, due to its p2p nature.At the moment this causes us some issues with troubleshooting circuits that face off against external providers.Is there nothing *nothing* store...
Hi actually we have the follow topology network:We try to merge both MPLS with inter -AS we have table on BGP for vrf prueba and announce and advertise the loopback 400 but is unreacheble for ping the networkConfiguration on cisco ASR-1:vrf prueba ad...
we are running ASR9K as BNG for PPPoE termination, when configuring the BNG to use the Loopback for the Radius outgoing packets. it ignores the command and use the outgoing Ip address to reach the radius we are running IOS XR 4.2.3 radiu...
HiActually we are integrating two mpls, one of then with IOS-XR on ASR9000 and the second with Cisco IOS 7600, someone have a opinion or a possible configuration for make this one.Best Regards
Hello people,a big project is on the way and I have to be 100% sure that we buy the right licenses for ASR9006 with ISM module for CGNAT.The ASR will be used as a BRAS/BNG for a large amount of subscribers (PPPoE and IPoE for IPv4 and IPv6)I see thre...
We have IOSXR 4.2.1 on routers CRS3 and ASR9K with all recomended SMUs; we need to configure the time synchronization for two NTP servers with the configuration below, but the routers became unstable; synchronize with one NTP servers for some time, t...
We have a newly implemented ASR 9010 and are trying to figure out how to best configure it with TACACS, as it is slightly different than IOS.In ACS, we have two groups: Group 1 and Group 2Group 1 allows full access in the shell command authorization ...
Hi,What are the hardware requirements for the nV Edge system?Im still not very sure even after going through the below;http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42clst.html#wp1011420Which lin...
In the Access List manual of version 4.2 http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/addr_serv/command/reference/b_ipaddr_cr42asr9k_chapter_01.html#wp1019212976 I read that there is a possiblity to filter packets according to...
Hi All,How to know our engine cards version? now we're using IOS XR version 4.2 and Can anyone explan to me what the XR command?Thanks and have nice weekend.Kversion.