XR OS and Platforms

Hello everyoneWhen I want to add more IP addresses to object-groups which are used in ACLs I receive the below error and I can not add more IP address to my object-group pfilter_ea[292]: %PKT_INFRA-FEA_DLL-3-TCAM_ERR : TCAM create region error: 'prm_...

Hi everyone,I hope you can help me figure out this, I've been going at it for a couple days with, little results. The scenario is an EVPL one. We have a gigabit ethernet interface where a maximum of 10 vlans can be configured on, each of these vlans ...

Hey all, i am having an issue where the number of subscriber sessions connected are decreasing.Memory and Hard disk state are normal.does anyone know what is causing this decrease of connected session? Thank you,

anyone using it ? Followed the guide fromhttps://github.com/ios-xr/bgpfs2acl A bit confusing especially i have almost no knowledge on docker commands. Managed to clear step 2. At step 3, when running "source run_container.sh"It seems like the docker ...

Hello All, I am new to multicast. And I have configured the Cisco XR router with a multicast configuration. Cisco XR is connected with a multicast receiver. and I see the following entries on Cisco XR. There are (*,G) and (S,G) entries. (*, G)'s RPF ...

Hello, What is the use of the "static-group" command under "router igmp" in cisco XR?When I configure  router igmp interface Loopback0  join-group 225.10.10.10 ! interface GigabitEthernet0/0/0/1  static-group 224.12.12.12 If a source pings 225.10.10....

Can an ASR9K work with two modules of different version?for exemple I Have ##################NODE power-module 0/PM0/SP 2kW DC Power ModuleMAIN: board type 0xf0038aS/N: DTM173103UETop Assy. Number: 341-00400-02PID: PWR-2KW-DC-V2HwRev (UDI_VID): V01Ch...

Hi,I have encountered an issue which is for me is unusual. As seen on the diagram below (example only), I have router with sub-interface Gi0/0/0/0.30 which is connected to BNG1 and BNG2 via pseudo-wire. The problem is even if I have already configure...

Hello,   I have a customer with two PPPoE connections.The first one is a FTTH and the second one is a FTTC.I would like to use the second one as backup.Customer side no problem, I use the track command.My problem is BNG side.The customer use public I...

Dear All, Recently I was doing NCS540 (N540X-16Z4G8Q2C-A) as a GM test. After 2 days of Survey-in, it could not enter Time-fix mode. There are very few instructions on setting GNSS in the file. N540X-16Z4G8Q2C-A looks like The U-Blox M8T module is us...

Hey there,I have been fighting (what I think is) a rewrite issue.  I cannot get connectivity between two l2transport interfaces in the same bridge-domain.  I've tried all kinds of rewrites and can't sort it.  I did verify that it works to each side i...

Hi there, I have two questions about licensing ASR9k, if someone can shed some light here on this matter. 1. When ordering ASR9k, is SIA software license a MUST for either FCM or Traditional model?1.1. If not, does the ASR9k get all the features of "...