Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi !!I have a cisco call manager express version 7 and when I go to Directory the corporative and personal directory are not showed and the status of the phones is Requesting ... ?What can I do to resolve this sitauacion ?Thanks !! ;-)
If I dial from IP Phone to IP Phone I hear our custom music on hold, but if I come in through 1FB/FXO/PSTN gateway and have user put me on hold I hear 3 beeps.Trying to think what would cause this -jason
On CUCM 7.0 I would like to set the system so that 1 person can do a call forward all for a group of phones, is this possible?
With Extension Mobility enabled, do these settings have any significance ? I suspect they will just match a DN that is not logged in ? Or will they indentify (for example) where a DN was unregistered but not logged out cleanly (like a site going into...
We currently back up the Pub. only , what happens if we need to rebuild Whole clusterDo we ? 1. Restore the Pub which will be on the latest we are on 6.1.x 2. Re-install the 6.0.x disk on each Sub 3. Upgrade each Sub to the actual release we are on-...
Hello What happens to End User info stored in CUCM if you change some LDAP settings?If a CUCM 7.x is integrated with LDAP for searches and authentication, and you decide to change the "LDAP Attribute for User ID" from say sAMAccountName to empolyeeNu...
How can we specify informations related with the CSR we want to generate, ex:organization ??To we have to edit directly the CSR data ? or a special WEB page exist ?
I have my CM6 set to use NTP, status is running and in sync but the phones do not show the correct time, they are an hour behind. Any ideas?thanks
Hi,working with CUCM v7, I have set users to "change PIN at next Login". However, when logging in to Extension Mobility, I get a Change PIN error 207, and cannot either get authenticated or change the PIN. I'm guessing I could change the PIN on CCM U...
Dear Networkers,I have installed, Cisco Meeting Place Express 2.0. I have also uploaded the license successfully, and have done the H.323 integration with CCM 7.0.When i call the number 33678 i hear the wecome prompt of MeetingPlace Express.But when ...
Hi, i get the request to change the display name on cisco IP Phone. they want to get the name of the caller display on the screen only for a closed list of cell number.do you have any clue where to start ?
How can I add 9 to incoming calls (calling party) with the translation pattern?Thanks
Hi,I am trying to implement hardware conferencing in an environment that uses multiple codecs. My understanding is that a CM software conferencing bridge only supports G711 codec and puts overhead on the server, so I am looking to use a hardware conf...
Hi,I'm trying to establish a phone call between two sites through an IPsec VPN. I am able to establish the phone call however the call is not going through the VPN. My scenario is:7960 phone --- switch --- 2811 router --- router --- 2811 router --- s...
How would I do this? The admin guide has unstructions for CallManager but not for CME. I am specifically interested in adding the Meetme softkey.Thanks,Diego
