Hi,I've 1 Cisco 7960 phone. I use it with SIP. The phone is "waiting for a call". So, when I call my number with my mobile phone, the Cisco 7960 rings. That's all good! But now: I'm thinking to buy 1 more Cisco 7960 phone. Same configuration. Same SI...
callmanager 4.1.3 Server in cisco ip phone 7912 line configurationMessage Waiting Lamp Policy Not available on this device.how we can enable the Message Waiting Lamp Policy
DearsHow to configure 7914 on CME ( CLI commands) and how to use it ( it's operation. note that i have 24 ip phone and one 7960 which the 7914 will be connectedthanks
I was under the impression that directory queries on a CM network were LDAP based, but someone I know is insisting that the directory is downloaded as an XML file. LDAP or XML?
we have a isdn DID number from 3598300 to 3598399 and ccme, the incoming number 3598300 should be striped in gateway and only 300 should be matched and reach the phone with DN 300. can any one help in configuration.
hello...anyone would explain how many telephone call supported when pvdm a has 2 DSP? what relation call with channnel? because i saw router has one pvdm but only say it support 32 channel. does it mean 32 call concurrent?
I will install one MCS-7816 with CMM, and wanted to know a little more about the hardware. I know that the machine will be an HP based on the product number, but I could not find any documentation for physical installation, expansion, etc.. Where sho...
hi guys...what possible trunk can be connected between pbx and cisco router in short cable (5 meter)? is it E1/T1... ops.. by the way do we only need plain e1/t1 without kind of signal such pri? please help... beside that how dialpeer would map to th...
hello does the regular fxo/fxs dial-peer configuration configuration will allow us to fax without the need additional config? example configuration from you are welcome. tx :)
