MPLS

Hi guys,I'm tring to test interoperability between Cisco an Juniper Boxes aboutpseudowire services.Let assume that I've an MPLS backbone, where the label distribution protocol used is RSVP, then MPLS-TE tunnels, I do not want to enable LDP on my back...

I'm trying to leak some static routes out of one VRF into several others. This is mainly to help get around issues with FWSM shared interfaces and load-balancing the firewalled traffic. Anyway, to try and ease the administration of the static routes ...

Hi. I am having some problems with VRF aware NAT. I have followed the Cisco documentation, but i'm still having problems with dynamic nat. The scenerio is i have a VRF called CUST1 which i can NAT if i use static vrf NAT, but not dynamic. The configu...

hi,allA router 805 that is regarded as CE to MPLS/VPN. the router only support 512K bandwidth on its Interface S0,and the MPLS line bandwidth to CE is 256K,It always discards data packets when I ping to peer after connected the router to MPLS network...

Is Route Origin as define in RFC4360 and RFC4364 is the same as Site-of-Origin as defined in Cisco IOS for MP-BGPThank you.

HI,I am configuring GRE tunnel between two PE's but tunnel is not coming up please advice how to proceed,Configuration of PE1;3845]interface Tunnel100ip vrf forwarding DCN-NECip address 10.1.1.1 255.255.255.252tunnel source 192.168.104.250tunnel dest...

Has anyone running ethernet/l2vpn over MPLS which can take an alternate path via a GRE tunnel over the internet? I have tried that and there seems to be the inherent problem that the internet MTU is 1500 only.Maybe I can further clarify my question:...

Hi Group,,, I have the following solution: CE1------PE1-----------P1----------ASBR1-------------ASBR2--------P2----------PE2---------CE2 AS1:PE1P1ASBR1 AS2:PE2P1ASBR1 ? IPv4 Unicast is working fine between CE1 and CE2 over a MPLS VPN from ...

Hi,I have read somewhere in this forum saying that the 1524 mtu size is a recommendation in an MPLS VPN context but it might not suit a l2vpn deployment. This is because l2vpn such as AToM need mpls mtu 1526 , right?The problem I am facing right now...

I created one LSP on the headend routeur.I want to reduce the part of trafic in this LSP. So, I want to do a traffic selection on my headend router based on the source address and source port.I can't find the mean to do this traffic selection.The onl...

hello can any one pls explain or give me more info about MPLS