Network Management

Hi all,trying to perform a RME InventoryCollection job with cwcli inventory I wasn't ableto perform this task.Anybody out there having done such a thing via CLI?Thanks for any feedbackLothar

I have a 6509E+VS720, running version ios 15.1(1), I think when firewall module Online Diag Status is unknow,EEM can automatic shutdown vlan2, excuse me how should I do? appreciate!!event manager applet FWSMdown event （I don't know how to set，please ...

Hello all I have a 1921 router with IOS 15.2 that I am trying to get the anyconnect .pkg installed on. I have made a thread on this here:                    https://supportforums.cisco.com/message/3769346although it has died out. What I need now is s...

Hiin LMS 4.2 how to delete the alarms mentioned in right of the LMS Window2)how to see if something wrong or critical issue happened on cisco devices let say FAN Goes bad on ur 7200 , when you open the lms on the morningthanksjamil

After I configured a 2811 router with "ip flow-export destination 10.10.100.100 9995 sctp", the router showed errors of  "%SYS-2-MALLOCFAIL: Memory allocation of 1708 bytes failed from 0x40394258, alignment 32, Pool: I/O  Free: 480  Cause: Not enough...

HelloWe're installing LMS 3.2 on a VM machine running Windows 2008 Standard edition (64 Bit).When running the setup the first message we get is:  You cannot install CiscoWorks LMS 3.2 application(s) on an unsupported operating system or when Terminal...

Hi,I am trying to run Audit reports for config change (Reports > Compliance and Audit > Change Audit > Standard). If I use "Immediate" Run Type a report gets generated with exactly what we need. If I try to use anything else so LMS can generate an em...

Hi,We installed Cisco prime infrastructure 1.2 and discovered our entire LAN swtiches and core L3 Switches. In Cisco Prime, we are getting information related to Device and IOS. But intreface ulitilzation information are not avilable. we used SNMPv2 ...

Hi ,I am using a 2851 router in mpls network. We had a power shut down activity recently and post to that i could not find any logs in the router.  Can anyone help me out in trouble shooting this issue.RegardsRaj

Hi Folks,I'm new in EEM and I'm trying to read a interface counter and save the value in a new variable. I will use the new variable to manipulate the value.Should I use SNMP (event snmp oid ...) to get the value? RegardsPadula

Hi NetproI have added manually the cisco asa 5520 to lms 4.2 , because automatically the lms didn't discover it ,however when i tried  to open the device using cisco view , i got the below error messageur help plsMessageCannot find applicable device ...