Network Management

Hi,I am having a few issues with the discovery process on LMS 4.1. The bug tool kit says that I can get a patch from Cisco to solve this issue.My question is what information do I need to give to the TAC to open a TAC case for this LMS tool ? Since t...

Was given this applet by Cisco Tac,  waiting to hear from them as well;event manager applet capture_cpu_spikeevent snmp oid 1.3.6.1.4.1.9.2.1.56 get-type next entry-op ge entry-val 85 exit-time 600 poll-interval 1action 1.0 cli command "enable"action...

I currently have EEM running some applets, and they're working, but I cannot figure out how to suppress the messages popping up in the console.  I send the output from a cli command to syslog using a watchdog timer.  I can do a "no logging console in...

HiI receive email when an interface comes down but because i have a lot of routers with a lot of interfaces i can' tell which one came down , is there any way to include the description under the interface in the email ? Also can i monitor the exis...

Hi All!    Got a strange problem here. We can't seem to SSH from the outside network into our router. Our router config looks straight forward enough. Can someone please take a look? Appreciate it!-Tom!! Last configuration change at 10:41:22 zone Thu...

Hello I have enabled SSH on my 3750 switches and notice that https is not working. Iam not sure they are related but seems to be oddly coincidental. Therefore find it diffficult to monitor using CNA 5.7.6. configs are given below      gvadc-sf01#sh r...

Hellois there any way to monitor traffic type passing through the WAN links on routers using LMS 4.2 ?

Hi,From what I can see Cisco Prime Infrastructure is 2 products: Cisco Prime LAN Management Solution (LMS) and Cisco Prime Network Control System (NCS)Under the 1 Product code of: R-PI-1.1-K9Can anyone confirm this?

LMS 4.0.1 installed on Windows Server 2008 R2 Standard with SP1. Created Inventory collection job, but couple of hours later, it is failed with all devices Not Attempted. Increased SNMP timeout on 10 sec, started again for only 1 device - collection ...

Hi,I'm upgrading from CiscoWorks 2.6 to Prime 4.0 that will be installed on a remote machine, but when I try to backup CiscoWorks 2.6 data in the old machine using "WindowsLMSBackup" tool, I get the message below:*************************************...

Dear All,I try run Fault monitor feature in LMS 4.0, but I got error like this picture :Is there any solution for this issue  ? I already fine to Google but still not find the answer.Thanks n Regards,Rp