Hi, we recently upgraded from LMS 2.2 with QPM 3.2 to LMS 2.5.1, is there a replacement cisco product that'll give us the quality of service monitoring reports that we had with QPM 3.2?
Hello Everybody!I am looking for any kind of confirmed informations (cisco docs) about licensing CW LMS in multiserver environment.I have to get one license per server or can I install redundancy topology using one license? (ie. distributed LMS appli...
I have Pix 515E i have a specfic url that i want to block. I relaize i can instal a server like websense or the like but i feel that is overkill to just block this 1 url. Is there a rule i can add in to the pix to not allow to go to that site? I don'...
When i try to update the configuration from RME->Config Mgmt->Config Editor->Config Editor Jobs. The running configuration becomes updates but not the startup one. i got this message from Config Editor "Deploy succeeded, Synchronization of RME archiv...
I need to deploy a configuration change to all my switches in my enterprise, some are running CatOS, some are IOS, and I even still have a few Cat2820 switches that are running Pre-CatOS. I want to make these changes using a NetConfig job in RME. In ...
I'm using a FWSM with software 3.1 and two contexts.I'm not able to manage config with RME 3.5 & IDU 13. Why?The FWSM's sysObjectID is not 1.3.6.1.4.1.9.1.522, from the supported devices table.Thanks for help.Andrea.
Hi,I am facing a problem in LMS 2.6 Common services, Device and credentials, Device management.When i select a particular device and view its credentials, in the report page under the hostname field i see the ip address of the device. This is the cas...
Just installed v.5 but can't connect using either IP or community. Can't find any documentation on what's required on the Cisco device end. Can someone help? I have a feeling that its just a matter of enabling a few commands.
Hi, i have configured the Cisco ACS 4.1 server, my switch is getting authenticated via Cicso ACS, now i could able to see the failed & passed authentication with the IP address from which i logged in, but when i see the "Logged in users" it shows 0, ...
i am using ciscoworks lms 2.5 to monitor 100 plus routers. since lms does not automatically shows syslogs in one window, is it recommended to have snmp server, syslog server and a traffic analyzer at the same time? also any suggestion on what open s...
I have a customer that has Ciscoworks installed. (Current modules installed are RME, Cisco View, Device Fault Manager, Common Services, Campus Manager)Can the customer do config pushes to the VPN and PIX devices using what they have installed or do t...
I have Ciscoworks LMS2.5 on a windows 2k server. I would like all config changes to be emailed once a week. I have snmp enable traps config & logging syslog facility pointing to my Ciscoworks sever.Where does Ciscoworks show these logs/changes and ho...
