Network Management

Can you upgrade a switch from version 12.2 to version 15 at once or do you have to upgrade to the next version until you reach the latest?   Thank you,   Laura

Hi I'm studying for part one of CCNA, but meantime my new job has thrown me in feet first into their Nexus3000/1841/1811 plus some HP procurve switch environment and I"m expected to know advanced troubleshooting.   So the problem, we have a Ruckus wi...

Q > SSO Standby cold.... andthen Redundancy Mode Disabled.... Why does not the recognized supervisor? Without reload the switch, any way to recognize the supervisor? Step 1> different versions of IOS htw_Legacy_BB_#2#*Dec 26 11:38:31: %C4K_IOSMO...

I need to set up secondary SolarWinds NPM Server.  I looked at the document for this command and is all I need to do is to add 2 SNMP management workstations is type the command snmp-server host (IP of secondary server) version 3 priv npm-account.   ...

I just downloaded and installed Cisco Network Assistant 6.3(3).  Now my topology views will only work when "Other neighbors" is selected.  Now, all of my Cisco VoIP phones show up as Wireless Access Points and cannot be separated out.  I'm going back...

HI, I have installed cisco Prime  LMS 4.2 on the EXSi 6.5 recently,however i can't log in to the web ,it display as follows: "Forbidden You don't have permission to access / on this server. Additionally, a 403 Forbidden error was encountered while tr...

Catalyst6506E  "IOS15.1(2)SY" Line card on slot1 was replaced via OIR due to failure. then, added ”wr mem” after that it had been under normal operation,after router was reloaded for maintenance, SNMPv2 have not been able to get MIB.And unexpected co...

I have created my own custome dashboard under Detail Dashboards. I have added 4 "Interface Tx and Rx Utilization" Dashlets. When I edit them, I don't see how I tie them to an interface? In the Interface Detail Dashboard, the entire page uses a Filter...

Ciao, I'd like to know which model are able to support a "true" ZTP without external configuration (like dhcp option for example). For this reason I'm thinking about ZTP USB but except for C800 series I didn't found information regarding C1100 series...

hello, i am looking for a hardware device with monitor port (vga preferably), keyboard port (usb preferably) and serial port that i will be using to connect to console ports of cisco equipment.i would like the device to have one serial port only.   a...

Hi All   After looking at the tacacs authentication logs in our ACS I notice that Prime is continuously trying to log into one of our switch. We have around 1000 network devices on our LAN and this is the only switch that seems to be having this issu...

[UPDATE 04/03/2018] Problem has been resolved   Hi everyone, I made script which pinging some IP's. The problem is with action end in conditional block because it causing problem with script triggering (getting error: "else" found without matching "i...