Hi I want to get the model number of Cisco routers and switches and I am hoping there is a way to capture the model number from the command line and putting it into a variable for TCL or VBS scripting like the command "show snmp chassis" displays the...
Forum Posts
Hello Engineersi am little bit confused of what is the IP address that i can remote access to it via SSH or Telnet in switch or Router is it (Interface VLAN) or even the (IP of physical interface)? And must be with same network pc to access remote sw...
hii i need help with hsrp configurations tho ive got the basics alr as seen in the above image, I've shut down the main interface g0/0/1 for r2. however, both routers have standby 'unknown'.^ r3 router^ r2 routereach sub-interfaces have their own vir...
Hello everyone. I'm working on a Firepower 1010 v7.0.1-84 in a test environment. To access the firewall dashboard, I need to enter the IP address 192.168.95.1.How can I change the inside IP address? I've been searching for several weeks and haven't f...
Hi everyone, We were try to change via cli the primary and secondary controller configured on a 9115 ap. While we were saving the configuration no error was shown, so we believed they were changed as we wanted. The configuration were shown still as...
Hi @All I need a solution to simulate the interface status to the below SNMP values(State) in gns31 : up2 : down 3 : testing 4 : unknown 5 : dormant 6 : notPresentThanks in advance!
Can we integrate FMC, FTD with ServiceNow directly?if yes please share supportive documents.Many thanks
I intend to have Frame Relay to connect 3 LANs in which the 2 branches are connected to the HeadQuatar (HCM). Yet I have just implemented the connection between HCM and the DN Branch and then I got stuck.(In these LANs, I also have a Firewall but I ...
Hello,cisco ISR4451-X/K9Is there a way that I can identify routes that are not being used to delete?We have hundreds of routes, and I believe there is a lot of dirt.
Hello,Please share OID value to check the available status of all slot/module and supervisor module operating status for cisco 4500 chassis.Thanks
Hello All,New to network, got this error message on our backup Job in Prime and not sure if there is a work around or fix for this. Nothing was changed on the backup config so not sure what was the trigger. It does say wrong value. "Exception during ...
Hi everyone,I'm having an issue with a CAT8000V where I am able to create a license smart reservation request, install the license, and everything is fine. After writing, I reload the CAT8000V and check the license status and it is no longer install...
Resolved! Restart 4G module
HiEvery now and then we have a router that goes offline because of its 4G module.What we do now is physically go to the router and put in a reload.Is there a way to automatically restart only the 4G module whenever the router detects that it has no m...
We downloaded a new BIOS to router and the tech del old but then new did not fully download. I am getting Unsupported package header version (1868653600)Failed to find bootable image on device bootflash:........autoboot: boot failed, restarting...R...
Resolved! SNMP OID of TCAM
If anyone can help out what is the current SNMP OID for TCAM?
| User | Count |
|---|---|
| 5 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
