If you have any features/improvement suggestions, let us know below.
Forum Posts
Resolved! DCNM to Nexus Dashboard
Installing a single node ND to replicate what DCNM gave us. DCNM was used to monitor nexus switches. During ND cluster bring up I have Fabric Controller or Orchestrator options. Neither seem to fit monitoring of the environment. Which is the best opt...
Resolved! how to change Data Network address on ND
Hello, how can I change Data Network Address on Nexus Dashboard because it is not changable as per the photo. BR,
Hello everyone, Our organization had issue with the primary ND cluster and needed to reinstall it. Unfortunately we missed to remove the "child" clusters in the Multi-Cluster setup. Now after the new primary ND Cluster is up and running I tried to c...
Resolved! NDFC POAP over L3
Is there a trick to getting POAP working on NDFC when the switch mgmt0 network is reachable over L3 to the ND mgmt network? I have tried everything that all the guides say.....This is the briefing of what my network looks like:I DO have a route added...
Resolved! moving from DCNM to Nexus dashboard
Im trying to deploy the Nexus Dashboard using ova. what subnet is required for the management address subnet. how many IPs does it require. the document suggests quite a large subnet. Is that required and is it routable over the network or is it just...
Hey Cisco,We are trying to install NDDB 3.10.4 (centralized standalone mode)When checking all systems are up:[a1548@iictzdaplv010 ndb]$ ./runndb.sh -statusController with PID: 1307236 -- Running!Nonetheless, when we want to open the GUI https://:8334...
Hi Experts, Im deploying NDFC for greenfield network. In resource tab its asking below, i don't know what this will be used for , should i keep it default value or I need to put some vlan and need to reserve it .* Network VLAN RangePer Switch Overlay...
Why would someone choose to use vpc advertise-pip border only rather than vpc advertise-pip? I'm looking for a circumstance/example that would make you lean one direction or the other. If you have vpc facing hosts within the fabric, isn't it ideal ...
Hello, on fresh installation of ND 3.0.1i on vCenter, Nexus Dashboard Insights service fails while trying to get enabled with message: job/pre-enable has failed: Does anyone have a clue of the reason? I'm running 3-App nodes, it's a small lab set...
Resolved! disruption of vpc heartbeat connection
want to move the vpc heartbeat connection of a N9K pair from a L2 switch to a direct cable.To my understanding -as long as the peer link is up- a disruption of the heartbeat link should not affect any traffic to the connected hosts.Is this correct? O...
Using the following version: ND: 3.0.1f NDFC: 12.1.3b Standalone virtual ND installation in a lab, using EVE-NG to create a square topology with N9Kv testing b2b BGWs multisite scenario. Everything looks fine after populating the necessary config to...
We have Nexus Dashboard Insights 6.4.1.45 running on a 3 VM Nexus Dashboard 3.1(1k). The Nexus Dashboard cluster is directly connected to the ACI 6.0(4c) fabric. APIC is connected to Nexus Dashboard Insights, and Nexus Dashboard Insights can extract ...
This is about VMware ESX (.ova) based deployment with 3 Data Nodes and 3 App Nodes. Nexus Dashboard v2.1(2d), Fabric Controller v12.0.2f. I am trying to upgrade image using Nexus Dashboard Fabric Controller but it keeps failing with below error: an...
Resolved! NDFC 12.1.2e Switch SSH Unreachable
At the moment we are updating our Datacenter Fabric Environment. Coming from DCNM 11.5.1 we've installed Nexus Dashboard 2.1.2d and NDFC 12.0.2f. After installation we've Installed the Backup from the Original DCNM successfull.Nexus Switch Software V...
Resolved! NDFC Switch Image Upload doesn't work
Hallo,we like to Update our Nexus Switches into our Datacenter Fabric. After the Image Upload is successfull done, the Validation show's the following Errormesssage:the md5 Hash of the File was checked and ok.Best regards
