Other Collaboration Subjects

Hi  I have HQ with CUCM / CUC . 11.5 . On branch i have 2901 router .  Requirement  I want SRSV feature . At branch i didn't install CME/ CUE yet. which version should i install and how to config SRSV feature . As far as my knowledge we have to conf...

Hello,I cannot connect to the IPCC script by an H323 gateways. Codecs are right, dial-peers also.I can see the following error in IPCC:CTIERR_REDIRECT_CALL_UNKNOWN_DESTINATIONAny idea ?Many ThanksDirk

Hi, guys. I am testing ZOOM for passive recording. I have GW -> CUCM -> UCCX. Mirroring is configured at GW Ethernet port. I can see Signalling and all RDP traffic between GW and UCCX during IVR greeting (tcpdump on a ZOOM Server). However, ZOOM cann...

Hi all, I want to ask can Cisco Meeting Server install on CUCM version 10.5.2? Should I upgrade it first to CUCM version 11.x? If can be install, anyone have the instruction how to install it? Thank you Regards, Fernaldy

Hello, I am starting a new project and i will need to buy Cisco switches, ip phones, AP's , routers etc.when i searched on internet most of the time it is not precise or they just send you a link to a locator, i am interested in finding out who are y...

Hi! We have voice gateway ISR2821 with dual E1 port module and two PRI from  different ISPs connected. It is configured as below: clock timezone GMT 3 0network-clock-participate wic 0 controller E1 0/0/0 pri-group timeslots 1-31 service mgcp!contro...

Dear Team, I just setup a sip trunk from my cucm to cube and I have the below error message. kindly have attached of my config and the debug messages.  SIP/2.0 500 Internal Server Error 

Hello fellow Jabberers! I have a question regarding Jabber and presence. So I have everything set up with Jabber and we are all enjoying it now.  The basic presence is working as intended but we are looking for something with a little more info.  Th...

On Cisco Unity Connection Administration version 10.5.2.13900-12  I need to disable MWI on many users/mailboxes.  I was hoping to use BAT Updates to make this change. I did an export to get the template, but the MWI enable/disable is not one of the f...

HI All, I am facing issue while using CMS Solution  Issue :- Call gets disconnected after 20-30secs  Call Flow :- SX20 (Standalone device ) >>>H.323 Gateway  component of CMS Bridge  SX20 is not registered to any VCS or CUCM .It is standalone de...

Hi , Can any one help me in installation of CMS server i have one ova file and two physical servers. I have to make one server as a data base and install Core and Edge on other server Can any one help how to achieve it??

Hi, Blessed day! May I know how to disable the strong password policy on CIMC password settings? We have purchased new UCS and we are trying to set the IP address of CIMC but you need to change the current password. Even we used password contains wi...

CUCM 10.5 is set up with a CUBE for PSTN access.   Connectivity between CUBE and CUCM is a SIP trunk.   If the sip trunk is set to require an MTP on the CUCM end of the sip trunk, then incoming calls work properly, MOH works, hold works, etc.  But....

Hi, Can any one share the ordering Guide for Cisco IP Interoperability and Collaboration System (IPICS). if you can also share some documents on IPICS licensing that will helpful.Thanks Bejoy Thomas