Other Collaboration Subjects

Hi everyoneI'm trying to configure a 1760 router as a SIP Gateway (see attachment for network topology).A PBX is connected on the E1 PRI interface, and has numbers starting with 0030898. What I need to do is make a call from a user A at PBX (i.e. use...

I have this scenario below: switchport -->(10/100Sw)IP Phone_01(PC) -->(10/100Sw)IP Phone_02 The switchport is configured with vlan 102 and auxiliary vlan 99.And the switch is configured with root guard. When I connect two ip phones to the switchport...

If I call my receptionist and have her transfer me to our route point number 6800 it will transfer but when I get to the IP Phone it shows connected on the LCD screen, but there is not audio in either direction. Like the calls legs were not totally ...

Is there any way in CM 4.x to limit the number of inbound calls that can be handled on a shared line. For example, I am trying to share line 1000 on two phones, each phone allowing 2 calls for that line. I want to configure the total number of call...

Hi there, I get an Attendant Console for receptionist in a data VLAN, while the pair of CCM cluster is in voice vlan. Access list will be applied in router voice vlan interface for protecting CCM cluster from virus attack. May I ask which port nu...

Inboud calls from the pstn thru an h.323 GW rings on the other end of ip phone users, picked up, however there is silence, users had to hookflash once inorder to hear the caller. CCM 3.3(2)spC Latest phone load.

Somebody knows how to monitor a CMM (H323 Configured)? SNMP? Syslog? Anything?

I am trying to design a callmanager express solution that will support the following:* 30 IP phones* 6 analog devices* 30 voice mailboxes* 1 voice t1 with DID* 6 POTS PSTN lines for backup connectivity* Daul internet connectionsI am looking for hardw...

Hi, Im novice in IP Telephony.I want to configure calls between h323 gateway and Call manager.I configured a dial peer pointing to call manager, and now I want to know, what I need to configure in Call manager.

When listening to messages in CUE, it does not state the calling number before the message plays. It states "from uknown caller" from all call from the PSTN. Internally it plays the number or recorded name.

Hi,We have a Call Manager and Hitachi PBX integration. Callers when calling from Hitachi side to an IP phone can talk to a IP phone user fine but when a IP phone user is not picking up the phone its not going to Voice mail, its ringing forever.The Hi...

I have CCM3.2.3 nowI have CCM3.3 or 3.4 or 4.x upgrade fileshow can I upgrade to 4.xI have read the cisco CCM upgrade guide, I still have trouble with it.any reply appreciatedthanks lot

I have IPtel setup with CCM 3.3. Right now I am doing SW conferencing within the IP tel users.But I cannot do any conferencing with PSTN users.What is the configuration steps that I should do to achieve this ( without using hardware DSP farm) ?

Hello,is it possible to execute an ASP page on the CM and send it's output to the IP Phone(the one that received the call) on an incoming call? Also is it possible to identify the caller?Any links and information would be helpful.Best regards,Victor