Other Collaboration Subjects

Someone out there has to have a list of supported/tested NIC's with CTIos 5.1 Silent Monitoring.

Hi,I am using Cisco AS5300 with TDM Termination and I get this error frequently. Can someone tell me what it means and how it can be resolved. Or atleast guide me where to find the relevant information..Oct 29 15:55:13.925: %ISDN-6-DISCONNECT: Interf...

Hi,I've installed IPCC Express 3.1 with g729 prompts and was really surprised to find out there is no way to record custom prompts with the same quality as the system ones. First of all this codec doesn't seem to be supported by any recording softwar...

Does CCM3.33 have the feature that each phone can set their own ring time or still same as before, system wide setting?

I would like to place a static ani in my pots dial-peer, how do I do that and what is the best way to go about doing this.

hello all,I have a problem with num-exp. The num-exp part works fine and route the incoming call correctly. The problem is that on the IP Phone the number showing that the incoming call is from is the number they dial that gets convert in the num-exp...

Hi,I have an echo when i receiving any calls from ISDN network.I m using ISDN BRI card to connect to ISDN network and i have cisco3660 router and 3.2SP G version on my CCM.Thank you for your helpMohamed

AAR seems only can prepend a prefix when wan in congestion, can we actually do tranlation?My case is:remote office E164 number is 16044564002,4002 is DID, we use 3 site code plus the DID as 7 digits line apperance(extension) because of the DID overla...

While importing Exchange 2000 users into Unity 4.03 system hangsAfter rebooting it works for about three triesExchange off-box through same switch

I'm a newbie of IPT phone services development. I've downloaded SDK, However, can I develop my service without IP Phone and Call Manager? (Because they are in my office, and I want to try at home).I've found the SDK included a CallManager Simulator, ...

I am trying to send images to my IP Phone using the CiscoIPPhoneImage tag. I am running CM 3.33, so that bug that everyone is talking about is not a factor I assume. I have gotten the Push2Phone application to work, but no other graphics using a Pu...

PROBLEM: Certain carriers disconnect calls if they do not receive an ISDN:Alerting message back within a given amount of time.ATTEMPTED SOLUTION 1: Get the carrier to increase their T310 timers (set at 20 seconds on my side, but only 10 seconds on ...

WHEN TRYING TO TRANSFER CALLS GETTING A MESSAGE ON THE DISPLAY SAYING "NOT ENOUGH BANDWIDTH". UNABLE TO TRANSFER ANY CALLS.ANY IDEAS AS TO WHY THIS IS HAPPENING.

We have had the system up and running for about two years now, Lately, however we have found that users are no longer in the unity system though they still have mail boxes in exchange. Not quite sure what is going on.

Hi,I have Unity version 3.1(5.0) and I cannot record a different voice prompt to " when busy " or " when no answer " through the ip phoneonly when I open web to the UM. In the ip phone I don't have these options on menu, need advice.Eyal