Other Collaboration Subjects

Call Manager 3.3(2) ES08We have been experiencing an issue where occasionaly our users experience a "pop" on their speaker instead of a ring when one of their secondary lines configured with a distinctive ring is supposed to ring.I'd estimate from re...

After searching this forum I now know that when a user transfers a caller directly to someone's mailbox and they don't complete the transfer before Unity answers the message is left (according to Unity) by the extension of the person that transferred...

I have 5 CCM clusters in 5 cities, all connected via a Gatekeeper. 4-digit dialing is set for calls between these clusters. All calls go through no problem.Here's the rub ...I noticed, upon finishing a 4 site upgrade from CCM 3.1.4 to CCM 3.3.2 spA...

Hi,Is there an option to permanently turn off the Missed/Received/Placed calls on the 7940 and 7960 IP Phones? or clear them automatically instead of doing it from the phone? Thanks,Venu

Hi,I am using TCL ver 2.0In the "timer" procedure, I've got the following piece of code. But when it comes to execution of this code, I get an error saying "leg [xxx] is in conferenced state". I want to interrupt the conversation and play the .au fil...

We have problem in interfacing the normal billing equipment with ATA.First we faced problem in polarity reversal. After a long search we cleared that problem by giving some value in the polarity field. But now we are facing a typical problem that is ...

Hello everyone.I was wondering if I could have a few questions answered from here.1) Does it matter which cisco switch is used, ie: 2950G, 3524-PWR, so on...2) Is there an advantage in going with an inline power?3) Are there any 48 port inline power ...

I have configured a Failover Unity. According to Cisco web you are suppose to use DIRT to back up a failover unity. The forced back using dirt works without any problems. The problem I have is when I attempt to do a scheduled backup. Within Disas...

Horrid question I agree but I have a customer who wants to place phones at a remote site and here is the catch. They have been doing VOIP over the internet between two sites for quite a while now. They recently put in CallManager at one of the site...

When I launch Unity 4.0 Sys Admin page and click the Subcribers link, the browser session locks up. There are some MAPI and UMR failures in the event log. Am going back to see if there are permissions issues, but I did run syscheck and all was succes...

On the Analog ports of the 4006 Access Gateway Module, are there any feature access codes? I mean can you initiate a meet-me conference from a phone on one of these ports? The vg248 has a configuration page where you can setup the feature access c...

Hello,I'm looking to attach an APC Smart UPS as explained at: http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_administration_guide_chapter09186a0080080b90.html#1027878How do I configure the SAP to do a graceful shutdown of the ICS 775...

Is there any way to diffrentiate between std and enhance sup software at the time of installation.

Can anyone clarify a few things for me. I have read a few earlier replies and found one CCO link, but ....Can this only be achieved with MGCP not H.323?Do 2600, 3600 and 3700s support this scenario (not just VG200)?I assume no other additional applic...

In my switch WS-C3524-PWR , i have a LOT of message :Feb 28 10:05:10.982: %LINK-4-ERROR: FastEthernet0/4 is experiencing errorsWhen many message appear , the phone drop the call or when we hang up the handset no dial......I dont have this problem wit...