On ISDN gateways I receive charging information from PSTN provider.I can view this in ie: show isdn historyHow to use this information in callmanager (ART) ?
Hi All,I have a CallManager v3.1(3a). The following services die without any events logged:PAServerPASPCS_en_USPASPREC_en_USStarting them by hand didn't helps.Somebody else with such kind of problem?Regards,Angel
I have working ICM (4.6.1) , CallManager(3.2) + IVR configuration Few agents can connect to ICM and works with cisco hard phones I want to agents could use Cisco Softphone ..and Media Termination .. All my hard phones configured in ICM in Configure->...
After changing the IP address of the H.323 gateway, softphone still attempts to stream audio toward old address when establishing call to PSTN. Old gateway address is no longer configured in Call Manager (3.14a) and all route patterns point to new g...
does anyone have the specs on the call capacity of cisco Gatekeepers in general, or a 3640/3660 modular in particular. I believe their should be some kind of chart that shows the number of calls you can top/platform.Thanks
MisterI have a 2610 with E&M interfaces . I use VOFR . When I make a call from equipment 3600 , with E1 , I don´t receive ringback from 2610 .I set the next commands in the voice pots :progress_ind alert enable 8 progress_ind progress enable 8But , s...
I have an NT 4.0 machine as a PDC and Unity is joining the NT 4.0 domain. I read the Unity installation guide and it keeps on referring to creating users on Active Directory. My question are:WIll Unity work with an NT box as the domain controller?D...
Got a 3640 router with a FXO port. I want all calls dialed to the analog number attached to the port to go to a DN off my Call Manager. How do I setup the VoIP dial-peer such that all calls match the destination-pattern? Do I used a "T"? Or shoul...
Hi all,I have another question for you. Is it possible to have a dual switch integration with CCM and an Ericcson MD110? What we plan to do is have Unity attached to the CCM and CCM integrated with the Ericsson?ThanksAndy
Is there a problem connecting modems to a VG248 and going out a 4000 AGM gateway? I was able to fix the fax problems by disabling all fax-relay but modems still disconnect and get horrible transfer speeds. Any suggestions?
I need to copy a voice message left on a subscribers inbox to a wav file or something similar. We used to have Unified Messaging and Upgraded to Voice mail only Unity 3.1.1. On the previous version the voice mail came in as an attachment file. Is the...
Hi , We are starting up a VoIP network using AS5350 as PSTN GW and 827-4V as endpoints. Is it an option to have an AS53500 as back up in case of failure of the AS5350. Could we use the same config ?Thanks
Is there a way that IP phone user can enable or disable timestamp on their phone when they listening voice mail? I know this is can be done on the Unity server through admin. Thanks
