Other Collaboration Subjects

We use the route pattern 9@ for outgoing calls and when dialing a local number with just 9 and the local number (9XXXXXXX), it takes a while for the number to go through. If we dial 9 and the area code-local number (9XXXXXXXXXX), the phone starts rin...

Hello, Does someone has got a sample config of a BRI for voice (H323 or MGCP) configuration at Austria ?I need to migrate a legacy pabx with voice bri to a cisco router.Much appreciatedDirk

Is it possible for a participant in an adhoc conference with cm 4.1(3) (NOT to initiater) to add participants into the conference?

hello all,Im trying to use the 9.@ operator on my route patterns with route filters. I want to have a route pattern for 9724XXXXXXX with the route filter...i set the route filter for area-code==724...when i dial i get the annunciator...the DN im dial...

Has anyone attempted to connect a CAS T1 using SF AMI and the T1 is provisioned for D3 AMI? Everything on CCO says D4 so I assume that this will not work. I just thought it was worth posting the question before paying to have the circuits re-provis...

I have a Cisco Media Module (CCM) gateway in a Cat6500 running 12.3(8)XY5. I'm trying to use the command "debug isdn q931" command but don't get any output when I make a call. I have one six port T1 module installed in the CMM card and I'm using po...

hi, can someone help me with changing the caller id for all the outgoing calls from all the extensions to a single pilot number.Thanks

we have MPE installed and can dial from an outside number into the server. but i havent been able to get our inside IPphones to connect up. i am confussed with the setup. i have a calling search space, partition, and gateway for the connection from o...

Hello guys,Could someone please point me to a step by step installation and configuration guide for unity 4.2. I have the following link but all it says is about the upgrade and nothing for intallation from the scratch. Here's the link:http://www.cis...

Hello guys,I am installing a 4.2 Unity(UM) but didn't recieve the PAK number yet. Will the installation prompt for the License at the end of the installation or at the beginning? I have two days to bring the unity up and can't wait for the License. I...

We are planning on using a common user/pin for "group" fast dial entries. The problem we are running into is that there are many groups that need setup, most with over 50 speed dials. Is there an application or something that would allow us to add ...