I enabled as detailed debug level and check on the enable trace log file but cannot find out the EM directory under Trace. CCM 4.1.3c:\Program Files\Cisco\Trace\EM\EMSvc.txtwhy I cannot see the EM directory even I genetate a EM events?
Hi , I want to Block Offnet to Offnet transfer from IP PHONES , i know in Serive parameter you can configure this but even after Blocking Offnet to Offnet transfer in service parameter SIP Phones Are still able to Transfer Off net to Offnet calls Pl...
If I apply a divert to a phone, is it possible to transfer calls back to the phone with the divert on, assuming I am tranfeering from the divert destination.At the moment, if I try this I get engaged tone, is there a way around this.Thanks
Hi , Getting this error message intermittently when trying to login to a Call Manager admin web page. It continues to give out this error message. Then if you leave it alone for a few hours - it seems to clear itself.The Call Manager version is 3.3(3...
We have CCM 4.1(3) integrated with Windows AD. But the initial installation make CCM use a domain controller which is not very stable.How do we safely reconfigure CCM to use a different domain controller. I tried change registry and .INI files, but t...
Hi,I need the recovery disaster for IP Telephone 7912Carried through one it changes the firmware, but when restart was made, it had a stop in my net, corrupting firmware.The telephone was stopped.
Dear pros,could you help on the below issueWhen I try to reset the phone using the callmanager administration web page ip phone does not get resetwhat could be the problemccm 4.1.3 running Thanksswamy
I have a strange issue, Can I check one thing first, when a call is placed to a hunt pilot does it understand the Max calls and Busy trigger settings of the phones in its hunt list, so if I have a phone with 1 line and max calls 4 ,busy trigger of 2...
Currently my callmanager cluster authenticated with AD, now we like to replace AD box with new hardware Please help for procedure to remove AD integration and back to use cisco DC.Thank a lotNatta
Hi,I want to update from a Device Profile the external phone maskI don?t has found any parameter to update the external phone mask. I think the E164Mask is the external phone mask. Is this correct? Has anybody test to update the external phone mask? ...
Are their any special PRI gateway configs that need to be done to get 711 dialing to work correctly. The called number is being sent to the carrier correctly which then initiates the 1-800 number to the 711 service center, but once it reaches that p...
Hello,Please can u tell me if the CME is integrated on the ios image c2801-spservicesk9-mz.124-3e.bin. If it is the case how to active CMEThanks for your help
Hi All!We are about to roll out a small CCME/CUE setup at a satelite office and we need a couple door phones. Does anyone have any recommendations on products and configuration styles?Thanks!Stephen
Hi ,Scenario is thisI have a hunt pilot setup in CCME of 3000 as per belowephone-hunt 1 sequential pilot 3000 list 2000789, 2001787 final 2000123 When I go to GK I seee that it has registered as an E.164 how do I negate 3000 from registering with GK?...
