Other Network Architecture Subjects

Hi, I want to configure two MSFC`s in the same chasis. By example I have in the first MSFC Interface Vlan 56ip address 156.175.20.1 255.255.255.0ip helper-address 156.175.28.202If I want to configure the second MSFC for HSRP do I have to change the ...

Is it possible to use a 3550 to route between two vlans and be able to control only certain pcs being able to access one of the vlans and the others to be restricted. Also can you use a 3550 to route between two networks(not vlans)? I am learning t...

I have two 2620 routers and plan on upgrading the IOS to 12.3 (mainline). For the IOS BIN I selected (IP feature set) Cisco recommends that the minimum amount of memory in the system be 32MB and minimum flash br 8MB. I have 8MB of flash, but only 26...

Dear AllIf I have got this scenario:PCs and switch, PCs (A,B,C,D) on segment1, and PCs(1,2,3) on segment2.If I tried to use ping coomand from PCA (segment1) to PC2(segment2), Now as we know switch will allow the frame to pass from segment1 to segment...

Is there a command that I can enter to find out what version of SNMP the some of my switches?TIA

Hi,I've a chassis config for a service provides that use MPLS.the question is: When do I need to use different kind of CFC,DFC and memory quantity for my modules ??The chassis config is:Cat 6509 NEBS Chassis for all Supervisors,No PS,No Fan 1 Unc...

Dear sir : There are some problem when I config static arp table in Switch3750 ? Following is description :Section 1 : If static arp command already config on Switch3750 , then the PC connect to Switch3750 . PC's performance is very bad . Include...

I have a LAN segment with over 100 meters long. Therefore, I use a switch to slove this over-length problem.So, is the user on the LAN can communicate to each other ?Will there be a collision, late-collision ?Thanks for all Pro

Can someone advise on CRC errors troubleshooting techniques. Thank you.

I'm trying to construct a serial cross-over cable to simulate a connection between a cisco 2610 and 1605 router. I think the cross-over pins are 1-7 and 2-8. Can anyone confirm this is correct? Thanks.

I've two network connected by IPSec tunnel.When i ping PC from one network to the other i have next->ping -f -l 1214 10.20.38.1Pinging 10.20.38.1 with 1214 bytes of data:Reply from 10.20.38.1: bytes=1214 time=78ms TTL=127Reply from 10.20.38.1: bytes=...

hello everyone,I have two 4507R switches and nine 2950 switches,each 2950 having two fiber ports of which one port is terminated into one 4507R switch and second into another switch.Again we have configured vlans (1 by default,2,3,4).Now the problem ...

I need some help.I have a Cisco Cat.3750 Switch. For the last 3 weeks i configured it by using Web Config. but now i cannot access, it seems web config not allow and couldnot see the web interface like before.Thanks in advanceSakdavin

I have to Internet connections with diffirent IPS providers, one is connected to Serial the other connected to FastEthernet 0/0. I am trying to load balance all out going traffic only without BGP is this possible? All traffic is going out the serial ...

i m running an HSRP with routers, one router contains Leases line while other backup router contains ISDN line as medias. and i configured the GRE's for the communicating to other locations, which all are running in EIGRP. but prob. is that whenever ...