Other Network Architecture Subjects

Hi,I have 2 C6506 Switches and 1 C3662 Router. Topology is as followsC6506A dual connection to C6506 - BC6506B dual connection to C6506 - AC6506A single connection to C3662C6506B single connection to C3662On the 2 switches I have 4 or 5 VLANS, all...

What is the minimum rommon version that will support Cat OS version 6.4.6 (cat4000.6-4-6.bin) on a Cat 2948G?Thanks!

Hi all,Using the MAC notification feature on a Cisco 2950 I noticed that several MAC table address entries are cycling through delete and add operations:(sample)History Index 26, Entry Timestamp 172524612, Despatch Timestamp 172524612Operation: Added...

Does anyone know if there is an easy way to dump the logs in the windows version of Ciscoworks 2000?

What is the command for logging into the VIP card itself on a 7500 router running 12.2 ? Have looked all over on CCO and can't find it .

Hi, I have a little problem, I don't known which version of IOS i have to install on my AS5350 to update it.My as5350 has: one DFC 4 PRI and two DFC NP60 anche the output oh the command "sh ver" is:Cisco Internetwork Operating System SoftwareIOS (tm)...

Hi, I have 1924 switch, and wants to recover the password , can anybody tell me the procedure to recover the password.Thanks & Regards,Ciscobuddy

I have a switch that does give output to the dir or show flash command. I can't seem to even get to the flash at all. Tried to tftp new IOS but to no avail. Tried to to reload from rommon with no luck. Any thoughts as to how to fix this or tshoot the...

Dear all,I remember that I find there is a link about which ROM bootstrap version can support what IOS version.However, I cannot find it now, would someone can locate this link?Thanksmak

If in the switch startup pocess,show the following information,is it normal? ***** The system will autoboot in 5 seconds ***** Type control-C to prevent autobooting. . . . . . ******** The system will autoboot now ********

hello,I'm experiencing link drops on one of our LRE links.#show controllers lre logshows the following for each drop:08:56:49 PM [716]: State PROFILE_LINKUP: Got event:Remote Hardware Reset08:56:49 PM [717]: State PROFILE_LINKUP: Got event:Local Ha...

I see there is an option to put secondary IP's on VLAN's on 2950's and 3500 LAN switches, but every time I try to do this the switch takes the command but the secondary IP does not show up under the VLAN 1 interface. Has anyone ever tried this?

I have cisco 2950 at one end and a cisco 4507R on the other end. Both the switches are connected with fiber links. There are two fiber main and redundant. Now i want connect both the main and redundant, but there will be a loop due to that. STP...