Other Network Architecture Subjects

I'm using OSPF as a IGP.When I use "show ip route" command, I can see the "forward metric" from the output.What is the "forward metric"?-----------------------------------------------------Router#sh ip route 10.17.17.0Routing entry for 10.17.17.0/24 ...

I'm implementing stateful NAT (SNAT) & have a query regarding how you create with multiple standby SNAT groups on an interface.Going through the options it appears that once the group names have been assigned these then have to be grouped under the s...

HiI have 2 segments,A & B, they are on the opposite side of the WAN Link.We have App.Server located in both segments.Is it possible, for a client PC located in Segment A, to see segment B as well.OR in other words the switch port (Where the client is...

HI,Can anyone pls help me in Perl scripting for writing a script for maintaining our leased line link status.Any site for the same will do.Regds,Gopi

where can I get a guide brochure and what tools i should use.I do this for repairing the fan of the case.who know the fan's parameter (such as: diameter, current, voltage and so on) of 4006 machine-rack.

I have 2 offices connected by a T-1 line. One office is unable to receive internet service, so i set up a NAT from one office to the other to allow for internet service to reach the non-internet office. The systems works great, Road Runner ISP provid...

I have been asked to analyze the traffic on our 2651 router. I have tried using Kiwi syslog daemon, but the information is cryptic and the pipes I see with the highest utilization do not neccessarily have the most lines in the output. Does someone ...

Hi,a have a cisco 1721 with a wic 4esw card and I am trying to configure two vlans to talk to each other thru the e0 port. would appreciate any help!!!

hi,I have connected a cisco router and a nortel router together with ospf running.The neighbor state shows INIT/DROTHERIf i shut no shut the ethernet port the neighbor state goes to full/DROTHER but goes back to INIT/drother##### the output of debug ...

HiAll GLBP documentation points to doing it on multiple routers.Would it be supported in a configuration where the 2600 has 3 ethernet ports, 2 for WAN and 1 for LAN with the GLBP being done on the 2 WAN ports?I'm looking for an inbound/outbound load...

Hi... do u know how i can delete a vlan?

Can anyone point me toward links that help identify when to use which show commands, in particular OSPF and EIGRP. Such as show ip ospf neighbor, show ip ospf protocols, show ip ospf interface.I get a bit confused sometimes.Thanks,

Please help! I have just purchased a cisco 1721-adsl router and a wic4-esw card. I am having problems getting connection between pc on wic card and network connected to routers ethernet0 port. wic ports are on vlan1 with and vlan has ip address. E...

I am having a 2600 seires router.When i telnet to this router and do some debug like Debug isdn q921 after issuing terminal monitor command, after few minutes the output vanishes and i have to telnet againg to see the output.Help neededEphraim Mani