Other Network Architecture Subjects

Hi,I am getting an error message when installing ciscoworks on 2000 server. the error message is that " cannot create a install dependency file ". can anyone help or encounter that error message before.Thanks for your help.Kaiser A

Does anyone know what the OID is to set the duplex and speed of a port on say a 3500 Switch, I would like to do this rather than telneting to a switch and setting the duplex manually.thanks

Hi,I need to understand that why we create the loopback interface, can we do all the things with this as we do with physical interface(Serial/Ethernet). What are the diffrences between a physical and a virtual/loopback interface.E.G this has been cre...

Problem happens on random selection of IOS devices (routers and switches)I changed the hostname of the IOS device (MSFC was the last one)I do a 'copy runn start'And to really make sure I schedule a reload for the middle of the night.In the morning th...

I have a Catalyst 3550 and 3750 stack in two separate locations, with GRE tunnels configured on our WAN links. Both switches are experiencing fairly high (70+ percent) CPU utilization, and the majority of this utilization is from the IP Input process...

I have a 3745 connected to T1 running fine @ 1.5Mbps. I'm upgrading to T3 @ 45Mbps. How many packets will the 3745 be able to push through/sec?Will I need a diferent card or bigger Router?

I've search around and am having trouble finding a comprehensive configuration/design guide for implementing diffserv based QoS.The real goal here is to provide good application response to interactive applications such as web and HTTP while preventi...

I have a cisco 7206vxr with PA-MC-4T1 , Can I used this module as a normal IP T1. I have to connect this module's T1 to the ISP T1 lines for data. I mean I dont want to used the channalized T1 , need to used whole T1 for BW 1544Kbps .

This is a simple question that I just want independant confermation on.In the setup for the ANI server, if the customer has put in the following for the snmp setup:192.168.*.*:public::::::private192.168.*.*:stuff::::::morestuffThat the ANI server fin...

Conventional wisdom about SVCs seems to fall apart in this document about SVC bundles: http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087c16.htmlThe feature requires SVC configuration at both ends. ...

We are seeing traps in our management station of failed SNMP authentication attempts on some Cisco devices. We would like to find out how where the failed attempts are originating fromdown. Using the syslog facility in CW2K is there a way to track it...

I have two sites on my campus - A and B. I have a catalyst 2950 at each site connected by fibre. How do I configure a port on site B's switch to only comunicate with one port on site A's switch?ThanksRN

Hello, in my workplace there is a network with several switches and routers, we want to implement some VLANs. My colleague propose to create one Vlan with all the switches and create another vlan with all the servers.Actually Vlan50 for local servers...

Over the past couple of weeks I've had numerous problems pop-up when we relocated our office and changed upstream providers. Most of those problems have been addressed and fixed. However, I still seem to have an ongoing problem that I do not know ...