Other Network Architecture Subjects

Hello,I'm trying to configure the Gigaport as Trunk port in WS-C2950G-48-EI Switch . I can't set the encapsulation as "Dot1q" . I can set as " Switchport mode trunk " . Is it ok to configure the Trunk port which will default take as Dot1q (OR) is the...

hi!can i use rip together with static route in the same router? if i'm using static route, will the rip routing still effective in the same router?

Can someone describe the differences between the scan timer and the keepalive/hold timers in BGP?TIA

Hi,Somebody knows how many servers or clients supports the license included in ACS? Or if exist some options for this licenseThanks

I have an office in Atlanta and one in Tenn. I can talk from My pc (192.168.68.202) to server (192.168.241.1) down there just fine. There is another network setup in our computer room with a server (192.168.25.100) that can't communicate with the sam...

We're bidding on a large project and plan on using LRE. Another company bidding against us plans on using PLC (power line communications) equipment.Besides being Cisco equipment, does anybody have some good reasons why not to use PLC (Telkonet) that...

Hi,I have a Catalyst 6513 with a Supervisor 720 and a MSFC3 card. If I just configure one VLAN interface and one physical interface, this VLAN interface comes up. But, when I configure another VLAN interface and another physical interface, the interf...

Hello,I am seeking some information regarding Ciso QDM. I am basically working on QoS for some time in my network.I have implemented Policy Routing, Traffic Policing & Rate Limit features using Cisco CLI. I just learned from a fellow about Cisco QoS ...

Hi,I have a STUN tunnel, one end is showing dead and the other is open waiting? I have booted the ports and there is IP connectivity between them - any ideas what ends causing the bother?Thanks

Dear All, Trying to monitor particular port on 3548 switch , but i can't. wants to connect sniffer and capture the traffic on port. can anybody tell me the command Thanks & Regards,Ciscobuddy

we will be setting up a connection to the Internet through two different ISPs. Both ISPs will be giving us a rate-limited metropolitan ethernet circuit. I wanted to run HSRP between two routers for redundancy as well as BGP between the routers and ...

Will Fair-queuing:?1. Need to bee on both sides of a WAN to Work correctly?2. Need to be on the Main or Subinterfaces?3. Will it put File transfer (Excel in particular)traffic ahead of Internet type traffic? If not how can I accomplish this? Thanks...

Hello,I'm using Cisco PIX 515E and I have an issue where me on the local network from inside interface is unable to access any IPs on outside interface. I have several static routes and people from outside are able to access those machines just fine,...

Hi Everyone,I am trying to enable PXE booting between VLAN's on a 3750 L3 switch. I have the IP Helper command configured on VLAN 1, point at the DHCP and Altri server on VLAN2, and have configured the ip forward-protocol udp command for ports 4011, ...