Other Network Architecture Subjects

We have a 2600-series router with a 4-port BRI module, and we have several dialers configured. These dialers are all going to dial a bank (the exact same bank, and exact same number), but they are triggered by different IP-addresses. To do this with ...

We have two sites linked by an E1.SITE 1 --------------- vlan10 -------------| ATM Switch |--------- | cisco 3524 | --------------- ------------- | |vlan 10 ------------- ...

New Cisco 3660 router powers on but does not boot up. Does it require a PCMCIA flash card to boot up ?

Hi,Can anybody tell me what the "transparent" doing here? I can not find it in the CCO DOC.router rip version 2 redistribute static metric transparent redistribute ospf 6 metric 2

Switch# uptime is 14 hours, 52 minutesSystem returned to ROM by abort at PC 0x0System restarted at 05:32:06 UTC Sat Jul 17 2004System image file is "bootflash:cat4000-is-mz.121-12c.EW1.bin"reapplied copy of config file and back up and running. Anybod...

I Have a 64 k line which i am using forconnecting to the internet so that poeplecan send and receive mail through microsoftexchange server 5.5. I have implemented NATand access-list to permit mail through theNAT interface. What stratles me is that th...

We have a Catalyst 3524-XL-EN switch whose RPS light is amber. The docs state that amber means:RPS is connected but not functioning properly. One of the power supplies in the RPS could be powered down, or a fan on the RPS could have failed.But, we d...

Hi,We have a SUN box on Catalyst 4003 and another SUN box on Catalyst 3750 on the same segment. Recently we had a message on both the boxes saying that "IP Hardware 'mac address' trying to be our address..." (as below) The 'mac address' is actually ...

I Have a 64 k line which i am using forconnecting to the internet so that poeplecan send and receive mail through microsoftexchange server 5.5. I have implemented NATand access-list to permit mail through theNAT interface. What stratles me is that th...

I Have a 64 k line which i am using for connecting to the internet so that poeple can send and receive mail through microsoftexchange server 5.5. I have implemented NAT and access-list to permit mail through the NAT interface. What stratles me is tha...