Other Network Architecture Subjects

Hi,I have seen alarms within monitoring system that my primary circuit went down. During that time, no alarms on the back-up appears in monitoring system, however we did not have service in the office. We believe traffic did not switch to back up alt...

I have a few of these switches and tried to use the latest stencils but the shape is actually wrong and the port groups on the switch front are wrong. Where can I download the correct stencil? Thanks in advance

I'm attempting to use the Cisco Anyconnect Secure Mobility Client to log into my work's VPN; however, whenever I get as far as entering my credentials, I get the message "Login denied. User Message: DfltAccessPolicy (The connection met none of the re...

Hi,I have a question regarding setting up L3 point to point link between two physical locations. we have a L2 link right now and cannot be monitored.we are looking to setup a the two links we have ( copper and fiber) between two near by sites as acti...

I am working on an ACS and switched an IP address.  When I went into it via the web-address it was asking for a license.  Is the license tied to an IP address or tied to the ACS itself?james

I have a 4500-X connecting to an ISP device. The ISP only have 100MB how do I rate limit the interface on the 4500-X without loosing the QoS service policy on the 4500X

Hello WS-C2960G-24TC-L   12.2(25)SEE3            C2960-LANBASE-MI would like to get the temperature status from this 2960 switch (and several other models. Normally this OID should be:.1.3.6.1.4.1.9.9.13.1.3.1.6But it does not return anything.The ter...

can anyone answer me about the differences between SPF and CSPF? is there only one different between spf and CSPF which is link examination or more ?

Hello everybody, I have configured a RSPAN sessión on source and destination switches in this way: SOURCE SWITCH (2950): Session 1---------Type              : Remote Source SessionSource Ports      :    Both          : Fa0/9-10Reflector Port    : Fa0...

I only realize Sup720-3B have the limitation of 235K route where full table now is near to 500k route. I need you guy help to answer some of question in my mind. 1) What will happen if I use Sup720-3B as my BGP router with full routing table. Will it...

As far as i know both technologies makes physical switch into a single logical one. Does anyone know what is the exact difference in both technologies? i appreciate your help. Thanks

Hi all,Quite possibly a stupid question, so apologies in advance!My routing tables are quite large and I'm looking to simply summarize them with a statement such as:area 1 range 10.21.0.0 255.255.0.0All I want to get clarity on is; will this affect a...

I am having an issue in a project. There are VTS and VCS VLANs at each site and Admin Building. These two VLANs are logically separated. Please check the diagram.Description:1, There are VTS and VCS VLANs at each site. Hosts in VTS VLAN and VCS VLAN ...