Other Network Architecture Subjects

how to activate a port on a router which takes in charge the broadcast ?and if there is an update for ios on the router which one to use ?thanks for your help

Studying for CCNP routing exam. Want to get this straight. Lets say a router loses an operational passive route and does not have a feasible successor in the topology table. It will then query its neighbors for a feasible successor. Will it also ...

HIHow can i set rate limit or traffic shape on an interface on the CAT2900 ?Thanks.

I am getting the following msg when power up of my AS5200, the T1/PRI card was working and recently wanted to play with my lab. Has anyone seen this error? Am I out of luck and this board is toast? Thanks for your help.Bus error at (return) pc 0x220b...

I have a question about Supervisor Engine redundancy. I currently have my network setup where there are 2 core 6509's (both with redundant Sup's in them) connected to each other.core1 - 1/1-2, 2/1-2 trunks to core 2 - 1/1-2, 2/1-2now.. i tested core1...

Hello All,While going through NAT Chapter I came across a VERY BASIC doubt about Access Control List (ACL). They used ACL to match the source address 10.0.0.0 /24. At one place they used following ACL to explain SIMPLE NAT:#access-list 1 permit 10.0....

HiI have got 2 (3550) working on hsrp with vlan 1 --vlan 14I have got 28 edge switches (2950). uplinked to 3550'sWill my DHCP client on 2950 get the ip from DHCP server using ip helper address configured on vlan interfaces on 3550 and DHCP relay opti...

DSL Network setup.Network Equipment:Cisco 6015 DSLAM Ios: 12.2(7)DACisco 2650 Ios: 12.2(11)T2Cisco 827 Ios : 12.2(4)YA3Cisco 827 _________Cisco 6105 _________Cisco 2650Brief Problem /query.1. Long delay while plug in the Adsl cable to Cisco 827 dsl ...

I´m planning to upgrade a Catalyst 4000 (2948 G) Switch that actually is running a very old CatOS version. Searching on the CCO I found that there is IOS versions for Catalysts 4000 too. My doubt is, Can I upgrade my Cat 4000 to an IOS software?, Is ...

We recently migrated DSL customers to a new router. During the migration process there was a mix up with dhcp pools and some users were given incorrect, but functioning, IP addresses. I tried to remove these users by doing a shut no shut on their atm...

I have a 7 location WAN all with 2621 routers. I'm currently running RIP on them. Would another type of routing protocol be better? They all come into one central location which is another 2621 and that is the only connection they make to the outs...

Hello there,I am trying to graph ip broadcast traffic on all gig-e ports of a 6509 with the IOS image (12.2). I am using snmp (MRTG) and polling ifInBroadcastPkts and ifOutBroadcastPkts and the problem is that the stats I'm seeing in the graphs seem...

Is it possible, that a DLSW Router can only have one ethernet port.That means, the Layer2 packets comes through the ethernet interface to the router. The router encapsulate the frame in DLSW an send the TCP packet through the same interface to the re...