Hi,I have a as5400, authenticating against a radius server. Where do I set the number of password retries? Also, can I prompt the user for their passoword. I tried the command aaa authentication password-prompt password: but it didn't work.Thank...
If I set-up a test network of say a router and a few Catalysts and configure CGMP, how can I test it to ensure multicasting is correctly set-up? I want to ensure CGMP works but don't have any multicasting software.Hope someone can enlighten me!Dazzle...
HAs anyone seen a problem when connecting a catalyst 4006 to a 3com corebuilder , when both ends are set to 100Meg Full duplex and are showing connected, I occasionally get the error message "%CDP-4-DUPLEXMISMATCH:Full/half duplex mismatch detected o...
Are there any alternatives to HSRP, as I have two CISCO 7206VXR routers that I am connecting into our ISP. I have been told that we dont connect into Cisco routers at their end and so HSRP doenot work, what alternatives do I have?
I attended the EIGRP Troubleshooting session in San Diego, and learned a lot - nice job.After looking at our network here, and trying to apply some of the principles discussed regarding meshiness, I now have a quick question.What makes an EIGRP query...
I'm having a problem with AAA. Users in the TACACS and local db are the only users who can authenticate to the 3640 itself (ie - vty access). I don't want dial-in users to be valid users of the vty. So here is what we had and did -and the ramific...
I have just installed an AS5400 w/ 216 modems and 1 CT3 card and an 8 PRI card. I want to know how to busy out channels on the PRI card. So I will be able to test the failover of PRI's. Also the last problem I'm having is when a user dial's in the...
Here is my configuration. I have 2 3508G XL connected using shortwave gbics' /cables. I am able to see my server and my devices. When I remove the shortwave gbics'/cables between the 3508G XLs' and install longwave/gbics', I am unable to see my devic...
Hi;this is kind of a primitive question but i really need to understand this.On NBMA interfaces when the neighbor command is used to identify neighbors does the router use unicast or multicast (224.0.0.5) to contact the neighbors??Also, when do i ne...
HiJust wanted to know how do i set up a Separate VLAN for Voice, This should be a Dynamic VLAN, i also have existin Data VLANS, SO was wondering what happens when i plug in any Voice Device i.e IP Phone..how does it detect which VLAN to communicate ...
How can you stop the sending of multicast VMPS frames (mac 01000CCCCCCD) on switch port even when VMPS is not used (VMPS disabled)?I have seen that switch ports on a catalyst 6509 (CatOS6.3) are still sending multicast frames to address 01000CCCCCCD ...
