Routing

All, I am pretty new to this forum and I have a good foundation of networking. We are working on a project and your help will be much appreciated. Here is the description of the scenario, I have two traffics coming from different switches (Alcatel-Lu...

So, I tried to enable the debug on the tunnel using the command  xxx#debug interface tunnel 3Condition 1 set It did not show any traffic  And when i tried to remove the debug it said  xxx#no debug interface tunnel 3This condition is the last interf...

I have a IR829 that is stuck in rommon -2 When I try to boot flash:ir800-universalk9-mz.SPA.156-3.M I get the following reading. rommon-2> boot flash:ir800-universalk9-mz.SPA.156-3.M Booting image: flash:ir800-universalk9-mz.SPA.156-3.M.... [Multib...

Hi, we currently have two subnets (192.168.0.* for PCs/Servers and 192.168.3.* for VOIP phones) each of which is connected to the internet via it's own router to a different ISP. See Current Network Diagram attached. Note that the connections between...

Hello all, I'm writing my bachelor thesis and have to configure Cisco Asa Appliance. My network is more complicated but for this question it's better to look like this: Server is in inside DMZ network. I want asa to translate outside ip address on 8...

Hi everyone, i have configured a Gre tunnel between a mikrotik router and a C870 Cisco router,i have configured the access list in cisco and routing in mikrotik as well. the situation is i want to grant access to a specific ip address (like google.c...

Hello everybody. I´m running a simulation with dmvpn over ospf, the hub supports the interarea stub no-summary with the spokes and have a connection with the core area 0 (intra-area). The problem that I have is that I can´t ping from a router intra-...

Hi Here is my topology left to right router A <eigrp redistribute static>---> ASA eigrp advertise out Gig0/1 and Gig0/2 ---------> router B receiving external eigrp routes via both ASA interfaces I need router B to have only one route in it's rout...

Hi guys I was after a quick bit of advice. I've attached a couple of screenshots from Wireshark. Subnet 10.53.199.100 cannot access a web system hosted on 10.29.128.100. They can ping/traceroute to it so connectivity is there. There is also a firewa...

HI all, i have a Cisco catalyst 4500-x series and i want to use this with Cisco 2960 switch which is max 1gbs SFP support how to configure 4500 series switch so that it can work with the other 1gb switches. Thanks Abuzer Ali

Hello, All I've stuck in the next stage of configuring my ISP interconnect with the folowing settings: PVC: 0/40,DHCP Mode (Dynamic IP, so no ppp session is required) These is a working input from my ISP, as I have another adsl router which was succ...

I am building a WAN and I having low throughput across (See diagram for more information). - I have 10 sites [ 5 sites in Europe and 5 sites in the US] connected via a provider VPLS- 3 routers are acting as route reflectors with same cluster ID [one ...