Routing

We are going to have new data Circuit and the termination handover is G703 Unframed E1 service and i have vwic2-1mft-t1/e1 Card on my 2800 series router.I have the following questions1) How to configure ip on this interface is it same as RJ45 or any ...

Hi, I have a situation where two Nexus 7k boxes are running iBGP and contain a significant number of host routes which are present due to a migration from one platform to another, as well as to provide IP mobility to the downstream segments. These ...

Hi Guys, I did port forward for Fortigate inside my 2951 Internet gateway but when I use my public IP it sends me to the Internet Gateway not to Fortigate Firewall! here is my configuration int gig0/0 ip address XXXXXX ip nat enable Ip nat outside...

Hi, we have a 2921 router with a direct connection to the internet (512 KBit) installed in a branch office. Normal internet traffic (browsing, downloads etc.) is going out / coming in directly through NAT, traffic to/from our Headquarters flows thr...

Configure public ip for web server access

I find in my ISP router, there are two public IP 116.10.2.23 defined for VLAN1 and IP 213.56.78.31 defined under G1/3, why we have two public ip, can we have only one public ip? now I need to setup my checkpoint,for external ethnet, I should use 116...

asr1000-rp2 after upgrade of rommon from 15.2(1r)S to 15.3(1r)S following issue persists: Initializing Hardware ... FPGA load not complete !!! Calculating the ROMMON CRC ... CRC is correct System Bootstrap, Version 15.3(1r)S, RELEASE SOFTWARE (fc1...

Hello, I have a 3560X-48T-L with image 12.2(55)SE5. I have look on cisco downloads and see that 12.2(55)SE5 is from 16-FEB-2012 and 12.2(58)SE2 is from 27-JUL-2011 so I'm thinking in upgrade to the cisco suggested release 15.0(2)SE9. 1) what should ...

Hello, I was looking for latest IOS release for C3560X and on link https://software.cisco.com/download/release.html?mdfid=282979193&flowid=2614&softwareid=280805680&release=15.0.2-SE9&relind=AVAILABLE&rellifecycle=MD&reltype=latest says that latest ...

Is there a way to load balance two gig Ethernets on an ASR 1001x to two gig Ethernets a ME3600? Thanks Robert Peterson

I have a new setup that I am labbing up. I have to add a small MPLS type network into our core OSPF network.  The link between the router and core will be an OSPF neighbor, not part of any VRF, and I want to import routes from one VRF into OSPF, and ...

Can anyone provide me some information on the VLAN limit of running OTV over the ASR1001I can find information on the N7K which is 256 and 1500 with later software versions. Just scouring the configuration guides now. Thanks