Routing

As above. I can't find any configuration info for any MPLS layer 2 extension features for the Nexus 7k devices, is this a strategic decision by Cisco to promote OTV?

Hi,Serial numbers from sh inv of 3845 router, IOS: C3845-ADVIPSERVICESK9-M, Version 12.4(9)T6 are not matching with Serial numbers from CiscoWorks (LMS V 2.6, RME V 4.0.5).e.g.HWIC-4T serial number from sh inv command is FOC11515N4D andHWIC-4T serial...

RTR#sh runBuilding configuration...Current configuration : 1722 bytes!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname RTR!boot-start-markerboot-end-marker!!no aaa new-model...

Hi Guys,I have a question in regards to route redistriubtion. For example:Router A has enabled BGP and EIGRP, and its EIGRP neighbour is Router B. Now Router A redistriubte BGP learned route to EIGRP process, Say, one of the BGP learned route is call...

Guys,We have a VPN using 857 and 877 routers as remote connecting in to a 2800 EZVPN Server.The VPN is working fine. However, the VPN connections sometimes (after a few hours/days) seem to "freeze". A "show crypt sess" shows the connections as Up/Act...

I have installed ASA 5520 firewall and 1841 Cisco router. firewall is connected to internet and the router. Router is connected to Network. There two networks available. I have completed the configuration. but problems. i dont know how to do the band...

Hello all.How do I find the default throughput supported by the Router 3925E?I need a router that supports 400Mbps line 3900.The 3925E supports? If so, you need to upgrade or add a EHWIC? If so, what can I addto support that throughput?Thanks for the...

Hi guys, I'm pretty new to Cisco and am in the process of learning as I go in home environment with some cheap old kit.I have a 1711 access router setup on an ADSL line etc and this works fine, I also have a 1751 with an ADSL card and this works as a...

I'm trying to set up some redundancy to a remote location via EIGRP and I'm stuck on whether or not any static routes or default gateways should be included in any of the switches located at that location.Up until recently, the sole route to the site...

Hello, I have a 2900 router with two GigabitEthernet interfaces. I want to configure the interface 0/1 like the primary, and the 0/0 like a backup, but I have a problem. When I disconnect the cable from interface 0/1 the backup interface began to wor...

Hi,im having issues with a Cisco 4948 L3, i have added the no ip redirects command on interfaces but it is not decreasing the utilization.. could you please assist me?thanks 44           0         1          0  0.00%  0.00%  0.00%   0 PrstVbl IPC Ms...

We have 150 m Verzion Ethernet circuit between NY and Boston, which we experienced intermittent problems. During the outages of one hour so, the router interfaces showed up and up all the times and showed no errors when showing ip interface. But Veri...

Hi guys,According to the below diagram, what might be causing the high RTT , where should i start the troubleshooting and which are the commands and checks i have to make in order to resolve this issue.