Routing

How do we control eigrp route advertisement in a multipoint GRE Tunne. On static GRE+IPSec tunnels we can associate distribute-list to a particular tunnel and filter out routes to particular site. How do we do that in DMVPN network.

Two questions here:I have used the following basic configuration to do rate limiting on a vlan interface on a 6509:access-list 100 permit ip any anyclass-map match-all ratelimit  match access-group 100policy-map ratelimit-10Mb  class ratelimit   poli...

Hi All,I have a customer router(1801) on which i am running a 2meg Ethernet LL to the web connected to fa0 and also an ADSL for backup on ATM0 Dialer1. I am planning to use IP SLA in conjunction with floating static routes to provide ADSL failover. T...

Hi All,We have 10 MB itnternet link at one of our DMVPN spoke site which is connected to Hub site (20 MB link)When I ran "iperf" test I found that we are getting 1.5 MB which is not even closer to the actual speed.The router we have at spoke site is ...

Hello,I have this topology in part of my networ:k Cisco7200---Cisco6500---Cisco3560---LAN1                        |                 Cisco3560                        |                     LAN2All devices are interconected via optical 1Gb/s links. Ther...

I have a 3640 router with 4 Fast Ethernet Network Modules (1fe-tx, 1fe2w & 2fe2w-v2) and a Catalyst 2912 switch.  I can not acheive a link between the 2 devices. All four will not get a link light and the interface(s) show no errors. If I plug the Ro...

Hey Guys,What would be the best way to do this? I'm looking for a more real time output similar to show controller T1 or show service-module. Is there something that will show real time stats for these types of circuits?Thanks,Dan,

Hi,Imagine service provider tells me that Gateway my company is connected is ready for "Dual Stack and Native IPv6".My border router is currently running IPv4 only.If I want to keep things simple and establish a point to point connection natively in ...

Hello,I have encountered this issue a number of times when working on a clients WAN circuit after a critical outage is resolved.I run the command 'show frame pvc' to list the active frame circuits, and my screen scrolls through pages of interface ent...

Hi Team,We have a 10 MB Internet Link coming from our ISP through there MUX.The link is connected to our Router 1841.Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(3i), RELEASE SOFTWARE (fc2)From past few weeks we are facing link sp...

Ive got a situation where i have three possible physical point to point interfaces that i can use for traffic.  one interface will be for normal LAN traffic and the other two will be reserved for FCIP traffic which is distinguishable by its port numb...

My Cisco 861 wireless router (CISCO861W-GN-E-K9) don't support EIGRP. What will I do to enable it? can someone help?it is a fixed configuration router.