Routing

hicould someone explain what is the difference between applying an ACL to an SVI on a switch or applying a VACL to a vlan?thanks

I  want to configure area 1 as NSSA and I want to filter some routes from  area 0 to 1 at router B. Can I configure router B to advertise default  route + 10.10.10.0/24 to area 1 and filter other routes that are exist  in area0? I don't want to use m...

Hello all, I have a 'public' network connected to a 'private' one. Two routers, configured as main/backup, interconnect the private and public networks.To allow a specific private host to go on the public network, I configured a static nat on the int...

Hi!We want to sniff a VLAN during peak hours, but we noticed that during that time, our equipment's (Cisco 7613 Router) CPU utilization reaches 28%(maximum). Is sniffing will increase the utilization of the router? We also want to know the threshold ...

Our new cisco 881 has a lot of unknown protocol drops on all the interfaces. How do I debug to see which protocol got dropped?

I am trying to nat the destination addresses of packets.if i use a static nat rule this works.ip nat outside source static 9.10.11.12 5.6.7.8so my packets from source address 1.2.3.4 are being sent by their dumb app to 5.6.7.8 and my router is sendin...

Hi, I'm in need of some advice and hope you guys and girls maybe able to help. We have a client who wants to install their own circuits into our Data Centre's but want us to manage the routers.  We usually allow clients to install thier own circuits ...

Hi,I've a server sonnected as follow:sw(fa0/1)<-->server1vlan 1 - 192.168.2.251/24   <---on switchserver: 192.168.2.6, mask: 255.255.255.0 default gateway: 192.168.2.251sw fa0/1 config:spanning-tree portfastno shutfa0/1 is up/up on the switch but sti...

I´m attached the parameters within submode Multilink.-Multilink: mpls traffic-eng tunnelsfair-queue 64 16 0max-reserved-bandwidth 90ip rsvp bandwidth 1000 1000ip rsvp resource-provider noneI´m configuring on ASR 1004 IOSxe 15.0Javier

Hello community,my company's network has two ntp masters. When issuing the command show ntp associations one 65xx gives me the output:Sw-MK-C6509-R-IS-MHX-A1#sh ntp associations      address         ref clock     st  when  poll reach  delay  offset  ...

How to originate default route in EIGRP as long as I get the default route from my Service Provide through BGP.I am not willing to do redistribution,summarization.

I need to configure two or three extra WAN IP's on a Cisco 881 router and am trying to stick with using Configuration Professional only for my setup and maintenance guides.I have found several guides to do this in IOS but nothing on how to do this in...

Hello everyone,I want to configure traffic shaping (or bandwidth) on ASR 1006 but somehow it is not working. Interesting ACL is not catch the traffic? You can see the configuration at the below.MY PC(10.200.0.217) ------> FW (with NAT - 194.X.X.X) --...