Routing

Does the ASA5500 series appliances do Dynamic DNS on the WAN interface to dyndns.org or tzo.com yet? IOS Routers do!Thanks,Jerry

folksi have a requirement to connect a small office, approx 6 users, in the US (washington) to the UK and i've been getting a few quotes for 2Mb leased lines and the results are scary, i.e. 25k (£) plusthe line needs to be encrypted so i'll be using ...

My cisco 2620 router always boots into rommon mode but after i reset it, it boots into the IOS. After i shutdown the router and power it up again it goes back to rommon mode ?I saved the running config to the startup config after setting up the regis...

I have a stack of 2 3750's.  I want to promote the member switch to become the master switch.  What is the command to do this?  Thanks!

I brought 2 cisco 2620 routers and only one worked properly the other displayed some unknown charecters in hyper terminal. Some friend of mine told me to try a bit rate other than 9600 so i did that and the router booted into rommon mode then he said...

HiI have a Cisco 1841 router connected to the ISP and I have the LAN side of the router connected to an ASA5510. The ASA5510 is in turn connected to a catalyst switch with 6 VLANs configured on it. The ASA5510 has subinterfaces which are connected to...

I have a cisco 2800 rtr, with 4 card slots.    Rtr will not recognize or power t1 wic or t1vwic cards in any slot.  IOS will not recognize serial / controller interfaces.    HELP?

Hello,1) Will OSPF install by default two equal cost routes in routing table, or "maximum-paths". has to be configured?2) If by default router only installs one route, how does it select one (from two equal cost routes) ?What is the criteria?3) if I ...

hi all,i configured cisco 1841 router having the following c1841-ipbasek9-mz.124-24.T2.bini confiured DHCP server in this router,but all the XP machines are getting the dhcp ip address but the windows 7 machines showing limited connectivitymy dhcp co...

Hi AllI have a scenario where i have a 3G connection (cellular interface) on a routeri need to do a route-map for certain traffic on this interface.so as the interface is a PPP interface that get a dynamic IP, i cannot use the set ip next-hop command...

anyone know if the sip SPA-8XCHT1/E1, 8X1GE-V2 SPA-1004 supports mpls configuration in asr 1004?Javier

Hi,I'm trying to configure an SSL vpn on a 1941 router.  The vpn connects and I can see the router itself, but not any other networks behind the router.  I created the ssl vpn configuration with CCP.  IPsec vpn works perfectly and the SSL vpn is conf...

Hi,can I change the Annex mode from A to M on an CISCO887W-GN-E-K9?kind regardsmanuel

hello I have a question anyone know how sometimes a fixed IP address on the interface when you assignWith Best Regards

Hi, can you help me with these basic questions:1) I try to ping ipv6 and I get a message "output interface required". I know that informing "output interface" is expected IPv6 behavior. The problem is that the prompt for "output interface" appears an...