Routing

I have attached scenario where i want to achieve a WAN active/standby failover with sp1 as primary link. SP1 has redundant mpls link at the HQ but at the branches they are not redundant. SP2 has point-to-multipoint leased line.I have tried to use IP ...

I know this is probably a fairly simple solution, but I have limited Cisco XPWhat I have setup is about 20 various switches with 2 Vlans. Unfortunately the gateway routeronly has a single interface for me to use so I the vlans on subinterface 0/0.1 a...

I have a multipoint frame-relay network linking R1, R3 and R4.  I also have frame-relay point-to-points linking R1 and R4 and one linking R4 and R3.  I'm running EIGRP over the entire set up and am trying to do unequal cost load-balancing to make the...

Hi.I have a 1760 with a 1 ADSL port, the carrier have a problem in the network and when carrier resolved the problem my internet connection is not restored, if I connect the carrier modem (2wire) the internet connection work, I changed the spliter, c...

Hi,While configuring an ipv6 static route, I see that if I specify the next hop ipv6 address then the traffic flows, however when I specify the outgoing interface instead of the next hop ipv6 address then the traffic doesn't flow thru, this is inspit...

I have two sites with MPLS connections (SiteA) and (SiteB) these sites are also connected via a man connection to each other. In addition, I have 70 remote sites connecting into MPLS. If one of the remote sites goes down (circuit failure). SiteA and ...

I would to know can i make the two boxes of 7609S working as Active/Active.

Working with a client that has a 3750 connected to a Metro-E to link up to their remote branches.  The 3750 has a L3 port interface connecting to the Metro-E.  Their provider is pulling a 2nd fiber (from a separate CO, different fiber path) to give t...

HiRecently a third party has begun to have problems with FTP and has informed me the NAT'd IP address is not being encapsulated into the Payload of each packet.  I'm not entirely sure on how this could be configured on the PIX firewall?Scenario:PCs o...