Routing

When removing port modules from the 7206, is it best practive to remove any config components before pulling the module?<br /><br />For example we have a Multilink interface that had x6 T1s that is no longer needed.<br /><br />IF I pull the modules w...

<p>Hi,</p><p>From the data sheet I can see that 12810 supports 40G/slot. Does that mean it 40G full duplex or 80G full duplex. If its only 40G full duplex, how can we get a switching capacity of 800Gbps for the system (40 X 10 = 400Gbps only)?</p><p>...

Two routers are configured with RIPv1 and RIPv2 respectively. Will both communicate or only one can understand ?

<p>Hi.</p><p>Hi i'am using 7204 for doing BGP I have reed about the wrowing of routing tables & the 7024'FIB limitation. SO, I have to get something else for doing bgp. </p><p>Wath could substitute de 7204 taking in to account that Ihve one BGP secio...

<p>Hi ,</p><p>I have a site with around 100 users. There are total 3 Vlans for each of the floors. Users on one floor are not able to access the  PCs of other users (on different floors) using the hostnames. But they can do this with IP address.</p><...

Hi.. Iam getting the following error on boot-up Scratch Pad Addr FailWrote 0000002FRead 0000001Cthis goes on repeating but system does not boot. Is this a hardware error.thanks and rgdsrajesh

hi,My core router 3845 connected to my remote site with E1 links and connected to my internal network with its sub-interfaces. The following is the sub-interfaces configuration.interface GigabitEthernet0/1.1 description *********LAN IPS********** enc...

<p>I have a server network area 12 at one locaton and an area 132 at different locations that are sharing the same network 157.171.53.0 /24 via glpb..</p><p>I am getting</p><p>An ospfIfConfigError trap has been received for router 10.69.12.1. The int...

Helloaccess-list 100 deny tcp any host 192.168.1.100 eq 80*****int fa 0/0 # ip access-group 100 outis it the correct ACL to prevent the specified host from internet.if not, could some one please correcting this.thank you

How to blockinter vlan communication with separate vrf's in catalyst 6509 switch.

<p>I have an 1841 with two internet circuits and I'm wanting to configure the circuits for failover.  Is there a way to have the router ping ISP1s default-gateway and if it fails use ISP2s gateway?  Please note that it is imperative I track an IP add...

Just got a new CISCO881-SEC-K9 which should come with Advanced IP Services Feature set and include EIGRP, DMVPN .... (CISCO881-K9 only has Adv. Security) http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78_459542.htmlBGP, OSPF, DM...