Routing

Is it possible to configure users on the internal network to use the DR Internet connection when the primary connection is full, or some percentage of being full?At the moment we have the default gateway of the users as a dynamic route learned from t...

Which of the 1800 series router is equivalent to 1751.

HiSorry, I know that this is not the appropriate forum, but I know that you can show me the way ahead.I am developing my work for completion of the course of Engineering and I will make on application of artificial intelligence (neural networks) in r...

Here is what I have:rtrCore--rtrT1Core--T1rtr--SWIf I ping to the t1 interface on T1rtr, I get horrible response. It will reply, reply, request timed out...no real pattern, but over 50% of the packets are lost. If I ping to the Lan side of the t1rtr,...

Dear guysi wnat to prepare my ccie lab1)which books i should read2)best simulator for practising lab3)which desktop to buy for support simulator4)how many equipment can i use in one desktop5)how many hours per day6)is there any books or sites which...

I have connected two 2600 routers back to back using DTE/DCE cable. I have set the clock rate 56000 at DCE end. I have also assinged IP addresses to the Serial interfaces. But when I connect them I get this message 'serial is down line protocol is do...

HiWhat is the difference between VWIC,WIC and HWIC cards?

! want to NAT 3 destination ip addresses to a single 1 address so that the requests coming for 3 ip addresses are translated to 1 ip address.

this is livington

Hi,I am working on a network design that could possibly use alot of Policy based routing and wanted to check a couple of points. the network will soley be made up of 6500's and with SUP720-VS's.1)Can multiple policy maps be applied to different inter...

hi pls tell me how to access gui interface of cisco 3845

Hi,We are planning to implemnt vpn on few of our routers,no wwe realized that we have base ios version and we need advanced security version. We bought the routers from a local vendor and thier response is very slow. may i know if teh upgradation to ...

I have a 128 ISDN circuit. When I initiate an ISDN test call, the circuit drops everytime after 20s...some debug info. is below:49w2d: BR1/0:1 LCP: EndpointDisc 1 fau_la (0x1309016661755F6C61)49w2d: BR1/0:1 LCP: TIMEout: State REQsent49w2d: BR1/0...

Hi...As per my understanding, in Cisco if I set MTU to 1500 that means Layer2 Payload... i.e--- Data+L3 Header--- Excluding Layer 2 HeaderIf I set IP-MTU, it means Layer3 Payload.... i.e---- Data+TCP/UDP header---Excluding Layer 3 Header... So if I s...

%EM_FPGA-1-FPGA_RING_FULL: FPGA buffer descripter is full..... Hi I am continuously getting the above error log in cisco router. What could be the possible issue? any idea? I tried with output interpretur but not so effective...