Routing

Hello Everyone!I am reading the CCNA 3 and 4 book, the EIGRP chapter. There is a bit that I just do not understand. Is there a mistake in the book? I have attached the diagram from the book and the text to the diagram, word to word, from the book is...

Hi All,We are planning to terminate a 4 mbps metro ethernet link on a Cisco 7206 router. Can anyone help me if there is any special config required on the port to bring the link up at both ends.Much appreciate the help.

Dear sir,how can i change the flow control on 2600 routerplz replysrinivas.d

scenario:vlans(Main)--router(Main)--15 branches(frame-relay)Findings;1. all of the branches except that of branch 15 are working fine.2. branch 15 is having 2 vlans (A and B). Vlan A could ping a server in Main whereas a machine in Vlan B will only h...

Hii have a project, an client has only 2 Public IP addresses, i want to use Network address Translation (NAT)and we want to Use legacy DDR to connect to the ISP with PPP encapsulation.How can i achieve a better config/Setup for this project?who face ...

we have an 1841 router with one HWIC-4ESW card installed in slot 0. The router alongwith two IBM servers is colocated in an IDC.The FE0/0 port terminates a connection to the public Internet and will be assigned the global IP address given by the ISP...

hi....i'am Sajan Simon working for Fakhroo IT SErvices,Bahrain.Well one of our customer require 2821 series with ADSL Interface & serial interface...other one is 1841 series router with serial interface...Can you guide me how to proceed

What Cisco routers support more than basic traffic shaping? I cannot seem to determine, for sure, which models support class based and distributed class based traffic shaping.Specifically, I am most interested in the 1800 series for my applications,...

RIP Default Problem:I am having a network between two routers A and B. There are three connectivities exist.a) Serial link between A and Bb) Two Layer 2 path between A and B via Fiber.I want to run RIPv2 only for my fiber path and utilise the fiber p...

Hello I am trying to configure a WAN link using a E1 MFT VWIC2 on a router 3725 when I try to configure the second E1 tyo establish a PPP Multilink I gethe following error message:%Insufficient resources to create channel grouper-cumana1(config-contr...

I currently reading Routing TCP/IP by Jeff Doyle. I decided to configure a mock version of his NSSA lab. I noticed that when I chanage the araea to an NSSA it stops receiving type-5 routes and does not recieve a defulat from the ABR. My normal def...

Hello, Guys i need help here. Your input will be greatly apprecaited.I have 4 router'sI will explain what the problem is Router # A connects with Router # B using IBGP. Router # A also has a OSPF connection to Router # B through Router C and t...

i am wondering how to detect layer 2 loops in a network, can somebody help me out the way to detect layer 2 loop in the network...