Routing

Hi,I have attached the next cisco configuration.I have two Wan interfaces on my cisco, I want to configure the output of all the inside traffic for the DSL Dialer1 interface and the access for my public IP Address (http, mail, dns) for the serial int...

hi. i want to do port forwarding to one of my server. i have a public ip. i want enable port range forwarding from port 10000 to port 11000. please help me in this regard with the configuration

i am designing a network with 1 central site and 165 branch sites interconnected through VPN. i would like to pick the right router for the headend. I am planning to use 3845 router. can anyone suggest please...........

Hi,I wanted to restrict LAN to WAN (traffic going from one vlan to another vlan)traffic on a 3550 switch to particular bandwidth.Can some one help me in providing the required configuration.RegardsSivakondala Rao

Thought IOS would be easy but not to be on this one.Issued the command copy tftp flash command from exec mode. It asked for tftp ip, source file and destination file. The copy went fine.Then to check whether the ios has been copied to flash. I entere...

running voip pri with older altigen pbx which only runs an emulated pri...what router provides ring back required by the altigen.

Anybody knows how to create a BVI interface on 6509? I tried, but couldn't make it. there is no BVI option in interface configuration mode.Thanks

I was wondering if the Cisco ISR 815 would work with my Cox (cable)HSI service here in Gretna, LA.I would like to get rid of the modem and router and replace it with the Cisco.The current modem is a Motorola SB5120 DOCSIS2.0 compliant modem, as it wa...

Here is my problem. I am atempting to connect my 2821 with an HWIC-4T to my 2801 with a WIC-1T via a standard T1 PTP leased line. After a router reboot or an interface shut / no shut the link will come up momentarily and then drop. I have tested t...

hi,i have two 2651XM and both the router installed with WIC-1ADSL card. now my question is can we connect the both the router back to back using ADSL connectivity? i tried to do the same but it was not working so i want to make sure whether its possi...

I always have save the cisco switches configurations thru telnet onto either a word or text file. I notice however whenever I saved configs it saves the page breaks, etc. Two questions, First what is the best way or steps to copy the switch config fi...