Hi Guys,I'm upgrading this chassis with a NPE400. I have read some documents which state a upgrade of the bootflash is required when I insert this new card.Am I right in assuming just installing the NPE card wont effect the config or IOS but may requ...
Just wondering if anyone knows if the Cisco 837 can be configured for a 512/512 SDSL connection? The SDSL connection is just a bridge connection (/30) where you get one static IP and the other static IP is the gateway on Telstra's end. If the 837 can...
Hi,Currently looking at implementing load balancing across 10 PPPoE based T1 links from the 1 provider. This provider does not support Multilink PPP nor do they support BGP. Router used will be 2811 with a 16 port etherswitch connected to a wireless ...
Hello all We have a few Cisco7304 we are having problems with unstable ospf. We are having two of them in a an enviroment where we have several C7401 , C7609 and C7513. The ospf of 7340 whith the other routers is very untable while the OPSF between ...
hi!Dear allIt is said that "clear ip bgp neighbour-address soft out" will make routing policy take effect WITHOUT reset the bgp session;but when I do a lab to set the origin attribute in bgp route this command doesn't works.I must use "clear ip bgp n...
I have three AS5300 Access Gateways. Right now i am using one of them and routing my calls thru serial port. The serial port of this is connected to the VSAT modem. Now i want to divide this further into two more Acess Gateways i.e. VSAT modem conne...
Hi Guys,I am currently doing some research on trying to find out the best solution for my company. I am patrial to private line over frame relay. Can anyone say something that would sway this? or give me some links to material to read?Has anyone h...
Dear expertsI have a 2501, today, it bootup again and again. as the following information:System Bootstrap, Version 11.0(10c), SOFTWARECopyright (c) 1986-1996 by cisco Systems2500 processor with 16384 Kbytes of main memorySystem Bootstrap, Version 11...
I am thinking of using a 1841 at an Muli-tenant building and offer different tiers of service. Can this router limit bandwidth ingress and egress per ip address?
We have a pair of IGX 8420s connected over a NTM E1 trunk. Over this trunk several 24-channel UVM connections are routed. Each 24-channel connection uses up approx 700packets/sec using g729ar8v compression. We are trying to switch the E1 trunk to a U...
Is it possible to connect 2 Routers Back to back using HSSI using CAB=HSI1 instead of CAB=HNUL. The Interface card on each router is a PA-H. Any body has any ideas ?
I have location A and location B and C connecting to location A using serial interfaces with frame-relay encapsulation and GRE Tunnel configure on the interfaces. I am using EIGRP as routing protocol. I also configured the HSRP on location B and C to...
Mrs, I have a problem with my 3660 IOS 12.3(13B), I configure a module of serial 4T (4 serial) with 4 E1, it's work fine, but when I configure other serial with WIC 2T I have a lot of errors and the WIC Interfaces are down. The interfaces doesn't co...
