Routing

I issued a "erase start" command on my cisco 837 router. After that i'm not able to telnet/hyper terminal to the router now. Will this erase start erase off the image file? What can i do to access back the router? Thks!

Hellowhen configure a FR traffic shapping parameters,frame relay cir frame relay mincirframe relay bc.."During congestion, provider will mark any traffic in excess of ( ) as dsicard eligible"what is in the blank, cir or mincir?thanks

I set the Date and Time on my router and then as soon as I reload, or power off and on, it comes back saying 16:00 PST Feb 28 1993. Any suggestions?

I have a 3725 with two two port T1 WIC's in W0 and W1. In W2 I have a T1-CSU/DSU-T1-V2 WIC. I am recieving a cd green light and an alarm light. The serial interface 0/4 is showing down and down. I want to confirm a correct configuration. Current...

Does anyone have experience with the following situation?Deploying bi-directional VSAT communication with the use of OSPF. My question in this particular case is how OSPF should be configured. Fact is that I do not know if this VSAT can be compared w...

Hi there,I am very new to cisco networking and have just been configuring the gateways on a couple of routers either end of a leased line (between corporate and the remote site). At our corporate office we have another router that goes out to the int...

When the the ISDN interface BRI0/0 is not on call the router shows "BRI0/0 is up (spoofing), line protocol is up (spoofing)".I know this is needed for IP to see the interface viable.But when the call is estabilished and the router says "BRI0/0 is up,...

The unit for bandwidth is kilobits/secWhen I checked that for policy-map it is in kilobits/sec, but when I checked the serial interface it was not,,,any hint about this ?Router(config-pmap-c)#bandwidth ? <8-2000000> Kilo Bits per second percent ...

Dear All,we have a cisco 3745 equipped with "1-port OC-3 ATM Enhanced perf Single mode Long NM 3" Module , do the specification of this midule match the G. 957 Standard ?second question : is it possible to connect this module to single mode mode ...

Dear all,Is any one having documentation about how to design Flexwan module for ATM.My requirement is that now i hv one 6509 Switch which having FlexWaN module on which we will terminate STM in which we give Bandwidth to all customer thr' that Pipe ...

I have classic situation, router, two interfaces, two ranges A on outside and B on inside, defined some translations and it all works ok. But I have one IP I'd like to be accesses from outside without NAT. I've made translation entry from B3 to B3 an...

HICan I continious ping from router like windows machine ?. like 192.168.10.1 -tThaksBiplob