Routing

I've got a requirement to use a WS-X2961-XL in a 2924M-XL to pull a PVC off of an ATM network and drop it off on an ethernet port.The WS-X2961-XL was discontinued long ago and I haven't been able to find much documentation on how to configure this th...

Is there any documentation anywhere that states an ACL will not work when compress stac is turned on for a synch serial interface? Is there any way to circumvent this behavior to be able to use an ACL and compression?Kind regards in advance.

Dear All, Around 30 to 35 ft away from our Divisional Office building, a Mobile Tower, by a certain Pvt. Company, is being erected for Mobile services to its customers. We are concerned but unaware of its adverse effect on our computer system an...

I have a facility that I am in the process of upgrading their LAN. They are moving from a router with a few swiches to a more campus environment. They will be running a 4506 as the core switch connected to a 2600 which is their WAN connecion. We run ...

Hi , I'm looking for any information regarding maximum number of concurrent TCP and UDP connections , which Cisco 3825 router can handle. Did not find any relevant stuff about it.thanx !

could any one give me a better perspective on DTE and DCE other thansaying DTE is a customer premise eq.and DCE is a carrier eq.thanks in adv.

Hello, well maybe this exist!!Would be very great to see for example when you redistribute a route (connected / static / Eigrp / etc) to another routing process in the Blue Box, what routes are getting applied to the redistribution when we use a rout...

helloi used to think that WIC2A/S speed is 128Kbps.however, when i connect it to 256Kbps, i can see by a WAN analyser that the speed can reach 256Kbps and there is no overrun errors in the show int s0.Is this normal?

Hi all,we are about split an area within our ospf network. So the question is can these two areas, which will be discontiguous, have the same area number? I know a quick answer might be to just change the area names but this will be a lot of work a...

Hi all,I'm having trouble on creating a atmfr circuit using SNMP Agent on CWM 15.0.Following the examples on the documentation, I'm able to create an atm-atm cbr1 connection (intra BPX8620), a fr-fr fr connection (inter IGX8410); I do it like this:sn...

We have an eBGP peering in which we advertise a prefix via the network command, with a configuration similar to this one:---router bgp XXX network 10.10.10.0 mask 255.255.255.0!ip route 10.10.10.0 255.255.255.0 Null0 254---The prefix 10.10.10.0/24 is...

Hello,I was able to connect to the aironet via a wired connection (typing in the device's IP in the browser window) when it was plugged into my Linksys Router (wrt54g). However, when I tried to plug it into a 3com switch (SuperStack 3 Baseline) I was...

My question is 2 parts mainly since I am unfamiliar with this new router. The Cisco site thusfar has not provided me with either an example config for this type of setup that we might work from. I was advised from a consultant to purchase this one to...