Routing

Suppose I have a remote firewall (pix), to which a web and a database servers are connected. Now I want to connect to this firewall via the internet by using the VPN technology. In my office (located remotely) my PC, along 15 other PCs, are connected...

Is it possible to do source based routing on a 3750 switch? This is my core vlan routing device.Here is the situation. I have a vlan which I want all traffic (including internet) to default to 3725 router, to be shuttled out it's serial port, rathe...

hello every one. I have bought 2 cisco 2500 routers, I connected them together with dte/dce cable, encapsulation on both serial are hdlc, clock rate on dce end both set to 64000, routing protocol used is rip, every time i enter sh ip route, cannot s...

Please,i configure pix to locate the server on dmz interface and host on inside interface.the problem is that the host on inside interface cannot reach the e-mail server (196.202.232.17).This is show run output:namesaccess-list accl_dmz permit icmp ...

Can anyone tell me how the BGP neighbor fall-over feature works? I'm wondering how it's different from fast-external-fallover.I've read the description here:http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080455...

Hi, I am getting a lot of flushes on a POS interface. Can someone tell me why i am seeing these flushes and how can I fix the problem. thanks show int pos 1/1/0POS1/1/0 is up, line protocol is up Hardware is Packet over Sonet Internet address is ...

Can someone tell me whether there is an IOS command to retrieve the device serial number on a MC3810 router?If not, is there another way to retrieve this besides looking at the back of the router?Show version does not provide this information.Thanks!...

Hellowhen configure ISDN backup floating static route or Backup interface, interesting traffic is configured by "dialer-list" and ACLs. only interesting traffic can triger the ISDN link, but what about after ISDN link active, still those ACL filterin...

Hi,We have two WAN links thro different ISP's and both are terminating in two separate Routers ( R1 & R2) . The ethernet Interfaces of R1 & R2 are connected in a Switch and we added R1 ethernet IP address range as secondary IP address in other Rout...

I have a 3662 core router, that has 4 T1's that are combined into a Multilink interface. I monitor this router with Solarwinds Orion Network Performance monitor. I am seeing alot of buffer misses; small, medium and bigStarting to get a little concer...

Hello, We recently bought a comprossion module for out 3662 routes connecting out WAN link (T1). My worry is that if i enable compression on the router, it will effect voice quality as we have voice and data traffic going over the WAN. To make ...

Hi!I have a Cisco 2610XM router with Advanced Security IOS (c2600-advsecurityk9-mz.124-3.bin).I have tried to use a BGP protocol but I couldn´t.The BGP protocol is not available in this IOS image?Thanks.

On 2600 series router I am looking for a feature that can send application specific traffic to my network management tool so that I can gather which application is sending how much data on an interface.Thanks