SD-WAN and Cloud Networking

Hi everyone, I have an ISR1111X with IOS XE SD WAN, and the problem I have is that the router is in vmanage mode and I cannot execute command via cli, and I need to add a command so that the router can reach the controllers.How can I change to cli mo...

Team,   I am getting the "Provisioning failed due to invalid parameter. Cannot add a fabric site if INFRA VN does not have VPN mapping." error while trying to add a new Border to a fabric site. Attaching the screenshot here. This started happening af...

Hi,I have question regarding hardware setup for the SD-WAN deployment. Can we setup vManage, vSmart and vBond on the same physical server for production (if resources are sufficient) and redundancy is achieved by lower level like vmware? Any argues a...

Hi, I have a very strange issue , Vedge is registered on Vmanage as below (Only CLI at this stage and no template)  I have configured ntp on the vedge and vedge has also internet access but cannot synch(time cannot be manually set too)  Anybody faced...

I am trying to deploy brand new ISR 4221 routers with 16.10 code on them. When I try to push templates, it gives me a weird error message as per below:<error-severity>error</error-severity><error-message unknown:lang="en">inconsistent value: Device r...

hi everybody,recently I've noticed that only up to 25 device can be added in pnp portal to generate provision file to update wan edge device in vmanage dashboard. But in my lab I have more that 25 nodes.I want to ask whether is any solution to add mo...

Hi ,    Is there any document to reference for vManage Controller failover scenarios?    

Two individual vManage cluster setup on two DC, using 19.2.1, with arbitrator to setup DR. We add all of the controller with vpn 512 ip, when create DR, we input all 6 vBond VPN 512 IPs, we can complete DR process, but after that DR status showed " D...

I am new to SD-WAN, and need some guidance from the respected forum…  Here is my basic question: What if I want to connect two branches, while one has a Viptela SD-WAN and the second one is from another vendor? Is it possible to establish an overlay ...

Hi Guys in the traditional networking at remote site we usualy have 1 VLAN for Data and 1 vlan for voice, in the Remote Site SD-WAN Base do  i need to create 2 Service VPN ? i mean 1 service VPN for Voice and another service VPN for Data pls advice  ...

Hi Team, In customer production and lab network, we both have down-in-gr wrong state issue when you show omp peer. When you doing vEdge upgrade and after reboot, you may found on the vSmart the omp peer state changed to "down-in-gr". But if you clear...

I have 10 SD-WAN routers with following DNA license5 router - 100 MB license - Aggregate bandwidth on each router 70 MB2 router - 50 MB license - Aggregate bandwidth on each router 40 MB3 router - 20 MB license - Aggregate bandwidth on each router 15...