Switches - Small Business

- I created two VLANs (44 and 45);- Assign the two VLANs for port 1; as untagged- Port 1 mode General;- PVID VLAN 44 port;- Set up a machine belonging to VLAN 44 she surfs the internet.- If I set this machine in VLAN 45 she does not sail.What can be ...

Hi, Hoping to get a little assistance with this.  Have found a few examples about the net, but all seem a bit different...They say picture worth a thousand words (even if a bad one, my apologies), but here goes: ...so here's briefly what I'm trying t...

Hi, I lost my switch password and do not want to lose its configuration. How can I recover the password thru the console port? Thnx! Brenda

I have a SG300 switch which is currently in L2 mode. I am not able to access the gui. How can I manually set the management IP from CLI

There is an error in the release note for firmware 1.4.1.Again like in the previous releases it isn't listed the revision of hardware V3 that exist for Sg300 series as stated here https://supportforums.cisco.com/discussion/12464431/sg300-20-hardware-...

Hello. All, Please can. Anyone show or explain to me how to trunk vlan traffic from my new cisco sf300 switch to the exesiting juniper EX2200 switch. Your inputs are highly appreciated.

please can any body sow me how to enable dhcp server on cisco sf300-24p poe  switch when ever i click in enable dhcp i get the following message :DHCP server cannot be configured. To enable the DHCP server, remove DHCP clients on all interfaces.  

Hello,I need help configuring inter-VLAN routing. I am setting up 2 VLANs plus the admin VLAN 1 as follows:- RV042 is used as a firewall (i'll probably replace it with something else)    - LAN ip addr 10.1.1.10    - SG300-10 connected to VLAN1 port- ...

Not sure this is possible....Two SG200's  with a common Enet line between them on Port 25 (Trunk).LAN is 192.168.1.x, with multiple devices ported into each switch.Because a Ubiquity AirMax is in one building and the 1921 router is in another, I'd ra...

Hi, I want to have an VLAN connection between two different switches (2960 and sg200).In default settings, all ports communicate.But I want to isolate a single port in 2960 and sg200 to communicate.What would be the settings in each port. thanks

I'm in process of replacing my switches (3Com Switch 5500G-EI 24-Port ) with cisco sg500-28 switchesI configured the switch to be in standalone mode, put in a SFPmodule in port 25 and connect it with fiber to an 3Com 5500G-EIi see the lights flashing...

I'm doing some test with 2 sg500 in a stack, when in L2 mode, the stack is working fine.  If I setup the stack in L3 mode to enable vlan routing and unplug the power cord on the master switch to test the stack, the secondary switch become master like...