Switches - Small Business

Hi I have a SG300-28 on which I am trying to import a SSL Certificate, Private Key and Public Key, but I can't get it to work. Information about the SG300-28: HW VID=02 Active Firmware = 1.4.5.02 Boot Version = 1.3.5.06 I am using the CLI, because t...

Hello Everyone. I have Cisco Business 350 Series Managed Switch, I want to implement a reduce Bandwidth to all ports from 21:00 till 07:00 hope someone can guide me to attain this. Thanks

Hi Guys,I connected three switch groups with a stack of 4, a single switch via CISCO DAC cable 1m and a stack of 2 via Cisco 10GbE SR transceiver in the PortChannel. The stack of 4 has the uplink to the MPLS router. There were no problems with the se...

I have Cisco SG300-28, SG350-28, and Catalyst 2960 switches. SG350-28 and Catalyst 2960 are connected to SG300-28 via a trunk. The Bridge Priority of Cisco SG300-28 is set as 4096. However, the Catalyst 2960 switch sees it as root bridge only for VLA...

Hello, yould you help me please with the problem ? We operated the Unifi U6-LR AP on the Zyxel XGS1930-28HP without any problems. We replaced the switch with a Cisco SBS350-48-4X. The access points use native VLAN 1 for management and other communica...

I have a Cisco SF 300-24pp switch. All the switches are connected in sequence, with the last one connected to the ISP modem. I want to configure the switch, but my console cable is not functioning due to it having a male console end and a female RJ45...

I have a new CBS220-24T-4G switch and it is very slow to connect, obtain a lease, something when connecting computers. If I plug a computer direct into my router, it connects immediately.  If I go through the switch, it takes about 45 seconds to conn...

I'm currently trying to configure the above switch at home for testing/lab purposes and am stuck at the moment. Can someone please tell me how to delete both VLAN 100's from my switch? I did a little research and found that there's a vlan.dat file on...

Hi, my cisco sf300 -24p has no any lights or conectivity, only fans sre working and thats all. Some assistance, what to replace, where to look?

Hi,i'm running two SG300-28 switches with a quite old firmware. The manual says that before i can update to the most recent version i need to upgrade to image version 1.3.5.x and upgrade the boot file to 1.3.5.06.Where can i find that ? On the downlo...

Hi All, I am trying to configure a cisco sg500 28 port switch to work with a Meraki MX.  I need to change the default vlan from 1 to 999 but when I attempted this and rebooted the switch it didn't take the change.  Is it possible for me to change the...

I want to monitor when ports go into error disable due to BPDU guard. On my test bench I can put my cbs350 into the situation and see that a port is disabled but I can't seem to SNMPWALK the OID. Does the small business series even support this? info...