Switches - Small Business

Datasheet says there can only have 200 ports per stack, and maximun 4 sw can be stacked.Which was the limitation?Can I stack 8 24-port switches (192 port total)Thanks               

Hello there,I'm wondering if that make sense to stack 2xSGE2000 and having a double connection on my server with bonding 802.3ad :SW1 --------------- BOND0/ETH0   |    |   |Stack on g24   |SW2 --------------- BOND0/ETH1Thank you in advance for your o...

I just recently purchased an SG300 10 port switch. After reading through many of the threads here, I was finally able to get the different VLANs to route properly. However, I'm having a unique issue that I'm not sure if it's related to the switch or ...

I'm new to managed networking.  So I'm having trouble understanding how to set up my switches properly.  I have a closed network with about 20 switches and 2 IDF's.  No router, and no internet.  I have a SLM 2024 in want to have 4 ports set up with a...

I am about to pull what hair I have left out! I have configured many a Cisco switch with VLANs and for some reason, once cell must not be firing today...I have a client who needs a simple wireless infrastrucrure: one WLAN for company traffic and one ...

I have connected 2 SG500x switches using an SFP-H10GB-CU1M SFP+ Copper Cable module.  Since the port shows as a 10G port, I would expect the speed to show as 10G as well.  However, it shows as "Unknown".  This doesn't leave me with confidence that it...

Hi,I am using a Cisco SRP527W router for our small business. As this device only has 4 LAN ports I want to add another switch so as our business grows I can add more PCs and VoIP phones. I would like to use a Cisco SF300-24 switch and before I purcha...

Does anyone have a consistent way for me to test throughput on a routed SG-300.  I tried using iperf with netbook on VLAN1 to netbook on routed interface running @ 100mb.  I was getting results as low as 40mb upto 200mb (sometimes even 2gb, I assumed...

Hi Cindy,I have a question about the SD2008 gig switch i have. it isn't functionig properly. When i connect my computer to the switch no led lights up but when i connect it to my sd208 it works. my computers have gig ports that is the reason why i up...

Hello folks. I'm new to the Cisco forums and new to Cisco switches. We just purchased 3 new SGE2010P's and 2 SGE2000P's last week and delivered on Monday.It basically boils down to this. After configuring the system time and hitting Apply and the sav...

Hello, We are in an organization of 80 users with 5 Sx300 series switches with the latest firmware (1.2.7.76). The network is mostly flat with all switches feeding into a Cisco ASA5505 acing as the primary gateway for Internet Access. Only our two 48...

Hello,We have been expereincing terrible LAN speeds thoughout our network and instead of complaining, it;s time to get off my butt and see what tools or functionality our SG200-50P can provide for us. It's very frustrating not knowing where the slowd...

hi, I am running the SGE2000 as my l3 core switch with multiple inter-vlans.have a customer requirement that needs to restrict eg. GUEST-VLAN10 to all other VLANS in the network.Only allowing access to the internet.It seems on the switch i am able to...

i have an sg300-28 running the latest firmware, and would like some insight on port-channel options.  below are the port configs i have for a LAG to my router.  i am currently using 802.3ad with LACP.  my router is a linux machine pulling duty as a b...